FDB750RCC0 Frigidaire Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Spray arm was melted on end from heating element in bottom of unit. Dishes were not being cleaned well.
-
Sandra from Wilton, NH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The dishwasher was "broken" and it needed to be replaced...
When I looked at my prospective home for the first time, the current "month to month" renters made sure to tell me EVERYTHING that was wrong with the place. One of those things was that the dishwasher was broken and beyond repair. Upon moving in, my brother in law asked "Did you try turning it on??" We did, it worked and drained...so why was it "broken?" The lower spray arm kept popping out mid cycle, then would get melted on the heating units at the bottom of the unit during the drying process. I easily found and purchased the part from this site. Once it got here, I literally just had to pop it on, no tools, no mess. Fixed!
Parts Used:
-
Brandie from Summerville, SC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
No water comming into dishwasher.
Cheked supply water line, water there but not getting into machine.Removed screws that hold machine to counter top, lowered adjustable legs and disconnected water line. I turned off power for safety.Pulled machine out about 8 inches to access water valve from the side. disconnect power supply wires, and water discharge hose, remove two screws on valve bracket. Install new valve and reconnect.
Parts Used:
-
thomas from Neptune, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
The lower spray arm became loose and melted on the heater.
Very simple to repair, cleaned the melted plastic from the heater, received the part within 2 days and pushed the new arm into the 2 bracket clamps and it was done. Since this was an older unit they told me the replaceable part number and the price was very reasonable..less then $30 for the whole job!
Parts Used:
-
Brian from Weaverville, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!