Quick Question!

Have you ever purchased from PartSelect.com before?

Models > EIMED60JMB0 > Parts

EIMED60JMB0 Electrolux Dryer - Parts

All parts for the Electrolux Dryer EIMED60JMB0

Below is a list of all parts for the Electrolux Dryer EIMED60JMB0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the EIMED60JMB0
1-14 of 116
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$55.95

High Limit Thermostat

This high limit thermostat is used in a dryer and monitors the temperature to make sure it does not exceed 260 degrees Fahrenheit. When your dryer temperature reaches 260 it will c...

$133.16

Heater - 3 Element - 5500W

This part is a heater, but may also be known as a heating element, and it is meant for your dryer. This is where the heat is generated during your machine cycle in order to properly dry your clothing. This model is a 5500 watt, and has three coils. If your heater is broken, that usually means there is a break in the coil element.If you are having trouble drying your clothes, you may want to check for a thermal cut out or a blown thermal fuse. For this repair you will need a number two square bit, a Phillips screwdriver, and a flat-head screwdriver.

$45.65

Lint Filter

Located at the front of the washing machine, this dryer lint filter traps lint and debris from the exhaust air flowing out of the dryer drum. This part measures approximately 14 in...

$9.91

Adjustable Leveling Foot - Black

This part could be found underneath a fridge, dryer, or freezer. The original foot may be cracked, broken, or perhaps missing altogether. If you notice the appliance is uneven to the floor or wobbling, it may indicate that the levelling foot needs to be replaced. You will need pliers and a block of wood to perform this task. There will be one adjustable foot found in the package. Lift the dryer and place the wood to keep it propped up. You may need to use the pliers to remove the old foot. Screw the new foot into place using your hand. Once the new leveling foot is in place, lift the appliance and remove the block. Test the machine out to ensure it is now sitting level.

$6.65

SCREW

$31.04

High Temperature Adhesive

This high temperature adhesive is used for installing felt and rubber seals on dryers. The tube contains 1 ounce of product. This adhesive is made to withstand extremely hot temperatures. Before applying the adhesive, ensure that the area is completely clean from any debris and is dry. You may wish to use small clamps to hold the material in place while it dries. If the felt has come loose or broken apart, this may cause your dryer to make loud noise, indicating that new felt or rubber needs to be glued into place. Use gloves to apply glue.

$6.86

SCREW

Sold individually.

$40.71

SENSOR-MOISTURE

$15.44

LIMITER

$47.70

DUCT-AIR

$20.64

LIMITER

$4.74

SCREW - M5 X 0.8 X

$21.88

Idler Arm Spring

$48.52

LATCH

This door latch is used in dryers to help keep the door closed during a cycle and releases the door to open when the latch is pushed. If the door does not stay shut, it can affect the cycle and your clothes will not dry effectively. In this case, replacing the latch can secure your door and solve the problem. The tools needed for this repair are: #2 square bit, Phillips head screwdriver, and a flat head screwdriver. Remember to wear safety gloves before beginning this installation project. Refer to the manual provided by the manufacturer for installation instructions.

All Parts for the EIMED60JMB0
1-14 of 116