ED5LHEXTD00 Whirlpool Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
the crisp pan tray was cracked on the right side
replaced it with a new crisp pan and now slides
in & out easily . no tools required,just a pair of hands
in & out easily . no tools required,just a pair of hands
Parts Used:
-
Henry from Pico Rivera, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
ice guide broken
removed front cover, disconneted elect. wiring, removed 2 screws, soaped latches on ice guide, snapped into place, reversed removal steps.
Parts Used:
-
Phillip from Fort Myers, FL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
I was getting plastic in with ice.
Remove ice bin,remove screws that hold the cover, then remove circlip at the end of the shaft.Remember to stack grinder blades and spacers in the order they come off ,then remove plastic nut that holds the auger . Remove broken auger and install new one then reinstall grinder blades as you removed them . Insert shaft back into bin and replace cover. Place ice bin back in Frig. and your done. The ice guide just snaps in . Jr.
Parts Used:
-
winston from Yatesville, GA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Wrench (Adjustable)
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice tray wasn't producing ice.
Traced it to the fact that water was't making it's way to the ice tray as everything else seemed to be working.looked up part on site which was water inlet valve, ordered part,installed in thirty minutes and now it works great again.JAY
Parts Used:
-
JAY from COLUMBUS, OH
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Icemaker water leaking due to crack in water inlet valve
I followed the instructions on your video. I'm a 69-year-old female with a hip problem. The most difficult part of the job was getting back up off the floor when I finished.
Parts Used:
-
Sherry from Fortuna, CA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers, Wrench (Adjustable)
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Knocking Noise When Opening@Closing Door
-
LOUIS from WOLCOTT, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice Mold finish worn off
Loosen to screws under ice mold and unplug power cord from icemaker.Lift out complete unit. Remove cover on ice maker,then 3 screws on end plate and remove end plate. Remove 2 screws that hold ice mold to frame. Make sure that the thermostat is moved to new mold. Reverse order to install new mold.
Parts Used:
-
Joseph S from Las Vegas, NV
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water not dispensing
found manuel online to trouble shoot once I took the front panel off I could see the sesor for the water side had two broken pegs that held it in place. We simply unplugged the wires and popped out the bracket which is all one piece for both ice and water. Put new one in and reconnected plugs easy and simple. Saved a huge bill from a repair man
Parts Used:
-
Rhonda from Big Lake, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
cracked valve
-
Howard from Middleville, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Valve damaged by water freezing in it
Removed old valve - very easy and intuitive. Identified damage and ordered new valve kit. Installation was easier than the instructions said. It was not necessary to trim the plastic water lines.
Parts Used:
-
John from Charlottesville, VA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
drawer broken
took old drawer out, put new drawer in
Parts Used:
-
Linda from Saint Rose, LA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Cover for ice maker shoot broke
-
George from North Las Vegas, NV
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door would not close on its own...had to give it a little extra shove
Took off the top cap, undid the 3 screws holding the top door bracket on, took off the door, repshove the lower door closing cam pieces, and then put the door back on...piece of cake, dude.
Parts Used:
-
Rick from Johnston, IA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Several door bins broken or cracked
Replaced the door bins in less than 30 seconds. The service person on the phone was very helpful in making sure I received the right bins I needed, the shipping was prompt, and I was very satisfied.
Parts Used:
-
Carol from Ocala, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door Shelf Broke
-
John from Aurora, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!