DU35A- Admiral Dishwasher Parts & Repair Help | PartSelect
Models > DU35A- Maytag
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(7)
PartSelect #:PS1524878
Manufacturer #:154106202
The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the he...
$4.73
In Stock
(6)
PartSelect #:PS11742743
Manufacturer #:WP489355
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this sc...
$4.88
In Stock
(1)
PartSelect #:PS11740613
Manufacturer #:WP285655
The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washe...
$4.88
In Stock
PartSelect #:PS451462
Manufacturer #:5300806833
This grommet is used in a number of household appliances. Most often it is used in the dishwasher as part of the assembly that mounts and holds the heating element in place. This r...
$4.95
In Stock
PartSelect #:PS11746849
Manufacturer #:WP912510
$0.65
In Stock
PartSelect #:PS11744050
Manufacturer #:WP74004005
This screw is well under an inch long, and is made of metal.
$4.88
In Stock
PartSelect #:PS11742713
Manufacturer #:WP488234
This screw is sold individually. Size: 8-32 x 1/4 inch.
$4.74
In Stock
PartSelect #:PS452144
Manufacturer #:5300808971
Sold Individually. Suggested to replace both at the same time.
$4.83
Special Order
PartSelect #:PS452142
Manufacturer #:5300808968
This assembly includes the 2 wheels and bracket.
$35.45
In Stock
PartSelect #:PS451182
Manufacturer #:5300803903
This pump motor shaft seal will help prevent the water inside the dishwasher from leaking around the shaft of the motor.
$54.93
Special Order
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water leaking under the dishwasher

  • Customer: Dennis from Tryon, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Wrench (Adjustable)
  • 70 of 73 people found this instruction helpful
I looked under and found that 2 brass nuts that secured the heater element through the base housing of the dishwasher has split down each side of the nut and no longer was tight enough to keep water from leaking around either end of the heater element. I powered down the dishwasher at the circuit breaker and then reached under the dishwasher and pulled away... read more

Water leak underneath dishwasher

  • Customer: Richard from New Orleans, LA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench (Adjustable)
  • 10 of 11 people found this instruction helpful
Unplugged dishwasher, removed the 2 wires clipped to the heating element, removed both cracked nuts, replaced with new nuts from PartSelect, clipped on wires, plugged in and did a test cycle. Based upon service quote from Best Buy, I saved myself $125.00 for just the call out, not including parts and labor. read more

Water leaking from under dishwasher

  • Customer: Eric from Holly, MI
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 10 of 11 people found this instruction helpful
Removed lower trim covers (2 Phillips screws) disconnected power supply at breaker box. Removed wire from heating element, removed (broken) brass nut, unclipped heating element and removed. Removed flat washers and replaced with new grommets. Kind of tricky getting them in there. Also had to lube them with silicone to get the element back through. Installed ... read more