Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DRSR483ED2WW > Parts

DRSR483ED2WW General Electric Dryer - Parts

All parts for the General Electric Dryer DRSR483ED2WW

Below is a list of all parts for the General Electric Dryer DRSR483ED2WW - Electric . To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the DRSR483ED2WW
1-14 of 94
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.90

Drum Bearing Slide - White

This is a drum bearing slide, also known as bearing drum slide, glide, or pad, that is fitted to a dryer. The slide functions by supporting the front drum as the drum rotates. This...

$4.23

Drum Bearing Slide - Green

The drum slides give support to the front of the dryer drum. As they start to break down it may cause your dryer to make noise or not dry clothes in an appropriate amount of time. This item is sold individually. You will need to purchase two as there are two located in your dryer. They attach to the outer-most sides of the bearing. The manufacturer recommends replacing both slides at the same time. Use this as an opportunity to clean out the lint and dust in the dryer to keep your machine running smoothly. This is a genuine replacement part that comes directly from the manufacturer.

$46.04

Front Drum Bearing

This front drum bearing helps your dryer operate as quietly as possible. It is about 10 inches in height and 22 inches in width. It is made entirely out of plastic and is white in ...

$17.69

Timer Knob

This is a timer knob and it is used in conjunction with your dryer. This knob is white with a silver trim, it measures to have a roughly three-inch outer diameter, and it accepts a D-shaped shaft. The most likely reason you will need to replace this part is if your timer will not advance, or if your dryer will not start. No tools are required for you to make this repair. To install this part, grab your old knob with a firm grip and pull. Make sure that during this first step the inside of the part has come off as well. Next you will align your new part to the D-shaped shaft and snap it into place.

$6.34

Duct Felt Seal

This is a duct felt seal for a dryer. The duct felt seal allows the front-load dryer drum to glide smoothly on the front panel. Your dryer will not function properly if the drum fe...

$4.69

D-Shaped Knob Insert Clip

This clip ensures that the knob is securely fastened to the control shaft, allowing you to properly select the correct time and setting for your dryer. If your dryer will not start or shut off, the timer will not advance, or the dryer shuts off too soon, the issue may be the control knob itself. This part is sold individually. Although this part fits with some different brands, be sure to check the list of brands below to make sure it fits with your dryer unit. Refer to the manual provided by the manufacturer for further installation instructions.

$24.29

Drive Belt

This is a dryer drum drive belt. It is 89.5 inches long with four ribs on the inside for a better grip. The drive belt on your dryer attaches to the motor pulley and then wraps aro...

$9.87

Rotary Start Switch

This part is used to start the dryer once you have selected a setting on the timer. The terminal locations on the new switch may be different, match up terminal numbers from old switch to new.

$34.23

FILTER & MESH ASM

This is a lint filter screen that is used for many dryers. It has a metal screen with a white plastic frame, and is approximately 13 inches wide. This part is sold individually. Th...

$3.59

Light Bulb

This lamp, also known as a drum lamp, illuminates and lights up the dryer drum when the door is open. If the light bulb in the dryer is burnt out or lighting is inconsistent, replacing it can solve this problem. No tools are required for this replacement. To repair, first locate the top section in the interior of the dryer and check the bulb. Next, unscrew the bulb by making three to four turns. Pro tip: the bulb cannot be screwed straight in, instead lean it at a 45-degree angle. Refer to the diagram provided by the manufacturer for further instruction and guidance. Remember to unplug the dryer from the power source for your safety.

$53.22

Rear Drum Bearing Kit

This rear drum bearing kit includes a shaft, ground strap, bearing, seven screws, and installation instructions. The bearing plate comes with a slot in it for the ground strap. Thi...

$11.10

Door Handle - White

This part is on the outer door of the dryer.

$38.71

Cycling Thermostat - 4 Wire

This thermostat helps to regulate the dryer's internal temperature. L210-30F

$69.06

Lint Trap Duct Assembly

This part includes the duct felt seal (PS9861764) and gasket (PS2577674). NOTE: Per manufacturer this part no longer comes with the sensor bars.

All Parts for the DRSR483ED2WW
1-14 of 94