Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DE590D

DE590D Maytag Dryer - Overview

Get Parts and Repair Help for DE590D

If you know the dryer repair part you need, you can browse the list of all parts on the DE590D, or you can search by name or part description. You can also find your part by where it is located on the DE590D by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DE590D parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DE590D

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Door Switch Kit

This part replaces two terminal switches in a dryer and prevents the dryer from running when the door is open. This includes two connectors. If your dryer will not shut off, start,...


Door Latch Kit

This is a door latch kit, but you may also know it as a door catch kit. It is designed for your dryer. This part helps hold the door shut on your appliance. This dryer door latch kit comes in two pieces: a door latch, and a door strike or clip. Both parts are a beige white color and made entirely of plastic. Together they are 2 inches wide, 1 inch long, and about 1 inch high. To replace the door latch kit, you will need a pair of needle-nose pliers and a number 2 Phillips screwdriver.



Sold individually.


Spring Retaining Clip

This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than usual during the wash cycle, your spring retaining clip could be faulty or damaged. Check the clip for visible damage, wear, and rust. If you notice any signs of damage, the part should be replaced. Remember to disconnect the power from your washing machine before starting this repair.


Screw & Fastener Kit - Front Panel








Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Switch sticking in on position

  • Customer: Don from Jacksonville, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 83 of 115 people found this instruction helpful
FIRST unplug dryer from electrical source, CAUTION, the top of this dryer does not open with clips, do not pry on top to open! On the front of the dryer look under the lower panel, and find two screws, one on the left side, and one on the right, remove these screws, and pull slightly down on panel to remove. Behind this panel find two screws holding the do... read more

Door latch broken

  • Customer: thomas from appleton, WI
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 44 of 45 people found this instruction helpful
I used my screw driver to pry the old female end of the latch from the dryer unit. I forced the new female part of the latch into the hole and bang...45 seconds later the door closed securely --like new! read more

broken clip for door latch

  • Customer: Shawn from Dover, NH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 13 of 14 people found this instruction helpful
popped out old female clasp on dryer itself with screwdriver, undid 2 screws on dryer door and door handle with phillips screwdriver, popped in new male clasp part, put door knob back on and put the two screws back in door and it was all set to go. Less than 15 minutes to do. Better than new and wife is happy. No more duct tape holding door closed now. read more