Quick Question!

Have you ever purchased from PartSelect.com before?

Models > CTX14CYXKRWH > Instructions

CTX14CYXKRWH Hotpoint Refrigerator - Instructions

All installation instructions for CTX14CYXKRWH parts

These instructions have been submitted by other PartSelect customers and can help guide you through the refrigerator repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the CTX14CYXKRWH
166-180 of 245
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

failed light switch

  • Customer: Jules from Crowley, LA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

broken shelf

  • Customer: Richard from Daggett, MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
after simply replacing shelf, I used the enclosed plactic washers to raise the height of door, so it would clear new shelf. It all worked as planned, thanks

no light in freezer

  • Customer: christopher from collegeville, PA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Connected the 2 wires and pushed in the switch until it clicked.

Broken shelf

  • Customer: Vanessa from Fort Wayne, IN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
The vegetable drawer cover had been broken for awhile, we are on the process to sell our house and finally decided to search for the part. I am very thankful for Part Select.com it recommended a compatible part and it looks great. Wish we bought it sooner.

Vegetable Drawer Cover had crack in the front

  • Customer: Larry from Shoreline, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Took 3 days and the Vegetable Drawer Cover arrived unpacked it and took the old cover out did a little cleaning and installed the new Drawer Cover. That easy.

broken center in vegitable drawer cover

  • Customer: Edward from Marina del REy, CO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
take new out of box. Pull out two drawers out of refrigerator. lift out old drawer cover place in new and replace drawers

refig light did not work

  • Customer: paul from east hanover, NJ
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
per your instructions

Vegetable drawer cover was cracked.

  • Customer: Shannon from Marysville, MI
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Took the cracked vegetable drawer cover out and drawer. Replaced with new vegetable drawer cover, put drawer back in.

no problem

  • Customer: ED from COAL CITY, IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
It was easy

Fridge too warm, fan sounding stressed

  • Customer: Joshua from ARKANSAS CITY, AR
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Removed lower and rear panels in freezer. Coils were completely iced over. Thawed coils with hair dryer using towels to absorb water. Cut the 2 wires (orange and yellow) of the thermostat unclipped and removed it. Cut short the wires of the new thermostat. Spliced new wires with remaining old ones using the wire nuts (2). Wrapped the splices with the electrical tape and clipped the new thermostat back into place. In the fridge section removed the box which holds the light socket, temp setting dial, etc. Inside unclipped the main connector which powers the light in order to remove the entire box. Unclipped existing defrost timer using the needle nosed pliers to gently wedge the clip away from the timer. Connected new timer and reassembled unit. Problem was really the thermostat, I decided it might be a good idea to replace everything, would have replaced the heater but I tested it for continuity and it was good.

The bottom part of fidge was warm with water droplets on the its ceiling.

  • Customer: Charles R from Renton, WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Removed Ice shelf,
Remove rectangle cover by removing the two screws and lifting straight up.
Pulled fan off slowly.
Removed two hex screws holding motor bracket.
Remove cover.
Remove two hex screws holding remaining bracket from fridge.
Pull wire off motor noting where they were plugged in.
Pull apart brackets holding motor and remove motor noting how the motor and brackets fit together.
Reverse to install.

Noisy fan

  • Customer: Robert L. from Eldred, PA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Emptied freezes, turned off power, took floor of freezer out [4 screws ], took two screws out of fan mounts and replaces fan. Reassembled by reverse process. Simple

Front Door Shelf Retainer Bar Broke

  • Customer: Aaron from Bellevue, NE
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Attached the retainer bar to the door clips and attached to refrigerator.

broken vegetable drawer cover

  • Customer: Pennie from Sutherlin, OR
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
We received the part. Pulled out the old tray and put in the new one. It fit perfectly and looks great. It took no time at all!!!!! Thank you for the prompt service too.

bulb out

  • Customer: Kenneth from Rowe, VA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I ordered the part, within two days we had received it. My husband put the part in and I really don't know what he used doing so. All I know is that the light works now and we don't have to use the flashlight. Thanks a lot.
All Instructions for the CTX14CYXKRWH
166-180 of 245