CTN1911GEW Magic Chef Refrigerator - Instructions

The frig had broken brackets on the inner door. I connected the clips to the trim piece and I snapped the entire piece into the slots on the door. Presto! All finished.

I unscrewed the support and replaced it with one that I ordered. It was fast and easy.

I just snapped the new clip in place.
I would like to thank you for your fast service. The part arrived the day after I placed the order. This is almost unheard of.
Thank You

We only knew what the problem was from a repair tech coming out. He was cool so he told us to order the part ourselves and install it. Easy as pie! A plug in part. We saved over $150.00 bucks doing it ourselves!

I pressed the end caps onto the retaining bar. Lined up the tabs and pressed the retaining bar back in place. The first side went in very easy. The second side was a little harder due to the tension of the bar and getting the plastic tabs lined up correctly and snapping them in place. Less than 15 minutes and the shelf retaining bar was fixed.

Unplug refrigerator.
Pry switch out with putty knife
Remove two wires from switch
Attach wires to new switch
Push new switch into slot

ohms-tested the overload relay and PTC component BUT failed to test the compressor. Turns out that it was the compressor was bad and a do-it-ourselfer won't be able to change out this component. Must be licensed to install freon back into the lines once they are separated. Also specialized soldering equip. and freon equipment is needed to perform this task. And if you add too much or the wrong kind of product or don't accurately install the bullet-piercing valve you can risk damaging the unit. So, ALWAYS Oms-test the compressor while testing the capacitor and overload and relay kit!!

put end cap on retainer bar, then align with mounting hole and snap into place. approx. time to install, about 90 seconds

bulbs were not burnt out. received the new switch in a few days. watch the short video, was good to see how it comes out. used a putty knife to release the defective switch, removed wires put them on the new one and posed the new switch back in. Not bad Part cost $11.00 7 dollars shipping so for 17 bucks it works great. nice to see what is inside the refer!

We looked up the problem online with the model number of the refrigerator. We ordered the part and followed the video installation that was sent with the order and was found online prior to purchasing

My problem is that my glass shattered into billions of pieces around my kitchen and kitchen sink it took me more than half an hour to clean the mess from the old glass. When I saw the new glass, I was very anxious to get it in my fridge . It took me less that a minute to put that glass on. It made my fridge look better because the glass was see through

Eased the putty knife under the edge of the switch housing and pried it off. Pulled two wires off the old terminals and hooked them onto the new one and reinstalled into the refrigerator body.

It was easy after it was apparent that the run capacitor was plugged into the compressor. This was determined from a parts diagram of the actual model refrigerator. The part was the same but the location on the video was wrong. A large screwdriver was used to unplug the capacitor from the compressor. The temperature range of the refrigerator is still too wide but it's colder.

I replaced the run capacitor wich is located near the compressor, i first turned power off to fridge than remuved capacitor checked for continuity and the capacitor was the problem thanks

I just popped out the old switch with a flat head screwdriver. Removed the connections and then installed new switch by reversing steps. Popped in back in and the light went on.