CSK30DRBAAA Hotpoint Refrigerator - Instructions

Snapped off the plastic plate covering the dispenser. Removed the four screws holding the mechanism in place. Remove the electrical connections. Pull the mechanism out and up carefully pulling the dispenser pad out with all the mechanism in place. Look at the mechanism before removing any parts to get a mental image so that reassembly will be easy. Remove any electrical switch or circuit boards and remove old parts before submerging the mechanism in hot soapy water for clean-up. The Clean-up will take longer than the disassemble and reassembling. After completion the dispenser works as it should.

Followed the video demo and would have been done sooner but for limited work space- narrow freezer compartment and the release tabs on the electrical plug. First home repair that the air was not blue and got done in under time allocated.

Pulled out old actuator pad worked the control for several minutes to free up the mechanism to make sure water would turn off. Then installed the new actuator pad.

Seemed simple and intuitive B U T the water tube receiver fooled me. Seemed to be on backwards. So, like my wife suggested, I D I D then read the installation instructions. Yeah! It's amazing what you can do when you just RTI. :-0

took olde out simple replacement. didnt need bearing slide already in parts.

Just used a screw driver to install.I highly recommend Parts Select. I ordered and had the parts within 3 days. Fantastic Customer service.

it was every easy i follow the instructions and took of the old and put on the new and now my frig look very good inside like new. thanks partselect ms miles

Very Easy, follow direction I the video.

This has been a problem for some time and had I known how simple it was to repair, I would have done it a long time ago. I followed the online instruction provided and had it done in under 15 minutes! I removed the upper drawer and shelf, the middle drawer and glass shelf, unscrewed the 2 screws holding the broken slide rail to the side of the refrigerator, applied the new slide rail in place of the old, replaced the glass shelves and drawers and that was it! Works like a charm!

The hardest part was getting hte right replacement drawer.

Removed old ice maker, then screwed in new ice maker. Only thing that was a little difficult was to hold the auger motor, while trying to unplug the clipped in plug on the old ice maker. I could have used an extra pair of hands.

Simply remove the two screws that release the slide. Remove the meat bin cover. With new slide, line up the holes in side wall and screw the slide into position. Check slide for rigidity. Replace the meat bin cover and slide the meat bin back into position. Done - simple fix.

Pull out old pan,remove the vent cover from front and install it on the new pan, done.

Piece of cake...did it myself, didn't even need to ask my husband

Had to take front panel off dispenser area. Then remove components and install new part. That was easy part. Problem was getting components back into front of freezer. Seemed like something was blocking it from going all the way in. Had to remove small amount of insulation and "jiggle" components and eventually fell into place.