Models > CDU300CWW P1188320W

CDU300CWW P1188320W Caloric Dishwasher - Overview

Sections of the CDU300CWW P1188320W

[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".

Questions And Answers for CDU300CWW P1188320W

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the CDU300CWW P1188320W

[Viewing 1 of 1]
Leaking
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Two upper rack rollers were broken
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent.
Parts Used:
WHEEL
  • Duane from Seattle, WA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Upper rack roller cracked then broke
First removed the end cover and clip on the end of the rack slide. Used a flat head screwdriver to push in the clip and carefully pried it out. Then using the same screwdriver, pried up on the rack roller clip attached to the dish rack. Once clip was free of the rack, slid the rack roller off through the front of the slider. Slid the new rack roller into the slider and snapped the roller clip onto the dish rack in the same place the old one was. Carefully twisted the plastic end cover and clip back onto the rack slider. Job complete. The trickest part of the job is removing the rack slider end cover.
Parts Used:
WHEEL
  • Jeffrey from Wilson, NC
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
original wheels were broken
I first removed the rail end caps by bending open the rail ends. They easily come off. The wheels slide out of the rack and the part snapped on to the rack removed. I used a screw driver to pry them off. New wheels are slid into the rail and snapped to the rack. End caps put back into place and rail tips bent back. Very easy.
Parts Used:
WHEEL
  • Todd from Powell, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!