The function of the grease filter is to trap grease into the filter from the exhaust air. The grease filter is intended to be used with certain downdraft cooktops and ranges. This grease filter is rou...
This surface burner knob is two inches in diameter. It is a black knob with a chrome trim, and white numbering denoting the temperature level of the surface burner. Sold individually. This knob accepts a D-shaped shaft.
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
January 16, 2023
What are the cutout dimensions for installing a jenn-air C221 cooktop?
For model number C221
Hello Mike, thank you for your question. The cutout width is 28 7/8th of an inch. And, the cutout depth is 20 15/16th of an inch. Good Luck and have a great day.
Was this helpful?
Thank you for voting!
February 17, 2023
On my Jenn Air model 221C standing behind the stovetop where the knobs are located looking on the right side, the large surface coil is at the back and the small coil is on the front. Both work individually fine from low to high heat. If I cut on the small coil on the front by itself its ok, while it is on low, I cut on the back or large coil and the small coil automatically goes to high. What is my problem? I have replaced both of the infinite switches on that side the small and large burner. I have replaced both the large coil and small one, I replaced the block (ceramic receptacle) that the coils plug into.
Where do I go from here to make it work correctly?
For model number C221
Hello Rick, Thank you for your inquiry. You could have a wiring issue as you have already replaced the parts that normally cause this issue. Check the wiring for any visible damage or loose connections and replace if needed. We hope this helps you.
I had put up with a filter that got more and more raggedy every year, but I thought my 30 yr. old range/grill top was too old for me to find an replacement filter. What a great service you offer. I found you by web-surfing, typed in the model #, and presto--you sent me the shiny new filter. All I had to do was pop it in and throw away the nasty grill (after washing the scent off to keep the bears out of my Colorado garbage.) Thank you!