AZ35H12D3BM1 General Electric Air Conditioner - Instructions

The Power Cord has a breaker on the plug. The breaker did not 'trip' during a power surge and fried the board in the plug. it melted. I ordered the replacement plug. Took apart the unit. Unplugged the power cord ends from the main unit. The ground wire (green) is screwed in. The other wires (white and black) are attached via push-on terminals. These are harder to get off and on since there are many and are in a tight space. May want to use some long needle nose pliers to assist. The new cable was attaced. There are two plastic clamps that help screw the cord to the unit. Only porblem was the new cord plugs in upside down so you will need to turn the outlet plug around. Turn off power, unscrew outlet and turn upside down. return power to outlet and plug in to complete.

Installed new filter..

I called the company that I purchased this product from and they gave me the part number that I needed and said to contact GE. I found you on the website and it was so very easy to order these replacement filters. Thank you for making this so easy.

It was very simple. I had already removed the old ones so all I had to do was insert the new filters. It was very easy after I decided which was the left one and which was the right one.

I removed the front panel and the louver assembly. Then I unsrewed the knob base and replaced it with the new one. Then I unsrewed the old louver ass'y and replaced it with the new one. Put the new front panel over the heater/air unit and I was done...

pull out the old filters and install the new filters. nothing to it.