AOES3030SS (P1132347NSS) Amana Wall Oven - Instructions

Unscrewed the oven from the opening. Removed the metal housing on the oven. Found the control panel. Hard to remove with the type of plastic anchors holding the panel on. Wasn't bad after that. Just had to keep track of the wires as you disconnected them. Reconnect to new board as you disconnect was the simplest. Worked just fine after that. nice new oven again.

Pulled out old element, put in new element. No problem. Works like new!

Turned off electricity to oven. Removed 8 screws with a phillips screw driver, pulled element with pan down and pulled wires out of back of oven. Pulled connection of 2 wires out of old element, these just pushed together, no wiring required. Used pliers to bend back brackets holding old element in the pan and removed old element. Placed new element into pan and bent brackets back in place to hold element. Connected 2 wires by pushing the connectors together. Pushed wires back into back of oven and placed element pan up against the top of the oven and put 6 screws back in place. Turned electricity back on. The hardest part was the awkward position of working laying upside down and reaching up to do the screws.

Removed back panel, unplugged sensor, removed sensor from inside oven (2 screws), replaced with new part.

Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.

bought used, oven light was damaged from previous repair attempt, without installation instructions removing the fixture was tricky, had to bend the housing tabs inward w/screwdriver to release fixture (more damage). once out the new fixture went in place quite easily, wires simply hook up, re install back panel, re-connect power, Have a nice Day!

One thing to help people would be to use the holes pre-drilled to insert a small screw driver into to hold the Hinge open. It actually has 2 settings and you will use both.