Models > 653AJ-V-CX > Instructions

653AJ-V-CX Admiral Range - Instructions

All Instructions for the 653AJ-V-CX
1 - 15 of 102
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Drip bowls were burned and tacky
First I removed the old bowls and replaced them with the new.
Parts Used:
Chrome Drip Bowl - 8 inch Drip Bowl - 6 Inch
  • Donna from Dallas, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
471 of 478 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drip bowls needed to be replaced
took old bowls out, put new bowls in, took a coffee break
Parts Used:
Chrome Drip Bowl - 8 inch Drip Bowl - 6 Inch
  • John from Chester, VT
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
453 of 542 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Stove top element not working due to bad receptacle.
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to scrap the whole range but I repaired it with $14.00 worth of parts.
The element is working great now.
Whenever I need appliance parts again I'll use partselect.com.
Parts Used:
Surface Burner Receptacle Kit
  • Richard from Carthage, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
191 of 208 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old drip pans stained
Replaced old drip pans with new ones - very easy - even a 68 yr old lady can do it!!
Parts Used:
Chrome Drip Bowl - 8 inch Drip Bowl - 6 Inch
  • Linda from Atlanta, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
216 of 425 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
one of my burners would only work half the time, and you had to wobble it to make it work
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires, connected the new element using the wire caps, and finished bye rescrewing the element backinto place.
Parts Used:
Chrome Drip Bowl - 8 inch Drip Bowl - 6 Inch Surface Burner Receptacle Kit
  • cindy from Sebeka, MN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
138 of 265 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
We needed new drip pans and no one carried the model we needed
we removed the old pans after first removing the electric heating element and simply inserted tne new pans
Parts Used:
Chrome Drip Bowl - 8 inch Drip Bowl - 6 Inch
  • sylvia from ventnor city, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
67 of 71 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Burned terminal block and filter board
Removed and replaced above named parts, rewired.Be sure to tighten all nuts that secure wires. I believe this is what caused the problem.
Parts Used:
Terminal Block
  • Joseph from Decatur, GA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Screw drivers, Socket set, Wrench set
90 of 192 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Element burned out
Unplug Stove removed screws pulled out
element. Lifted off the wires with a pliers they slid
onto the element ends that were pointed up
was very easy.
Parts Used:
Bake Element (15 Inch long x 19 Inch wide)
  • Anita from Hudson, CO
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
17 of 27 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Purchased home but stove had no broiler pan.
Purchased 2 piece broiler pan from this site
Parts Used:
2 Piece Broiler Pan
  • Raymond from BLOOMINGTON, MN
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
14 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
spring broke on one side of door hinge
Pulled the stove out, removed the sides and attatched the new springs( replaced both while the stove was out). Worked like new and put the stove back.
Parts Used:
Oven Door Spring
  • Travis from Lexington, OK
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
13 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Burner was out but the burner coil worked on onother burner
Replaced receptacle but it was not the problem. After further inspection I believe that the problem is the switch. The switch is on order now from Part Select.
Parts Used:
Surface Burner Receptacle Kit
  • Richard from Orange, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
10 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
burner receptacle burned out
Worst part of the job was removing the old screws that held the two old rectecles in place for the two burners I repaired. Once the screws were removed cut the wires stripped them and used the porceliean wire nuts provided with the kit. Easy job and good instructions.
Parts Used:
Surface Burner Receptacle Kit
  • Michael from N. Haverhill, NH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
8 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door Spring Broke
Removed 7 screws on sides and one on top of stove. Replaced both springs (only one was broken but did both). Took around 15 to 30 minutes from start to finish.Fastest shipping in history during holidays without paying anything extra.
Parts Used:
Oven Door Spring
  • Thomas from Van Nuys, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
7 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Stove top wouldn't come on. Oven couldn't go higher than low heat
Had a technician from Home Advisor to check the problem out with my Whirlpool Double oven(1 1/2 old). Paid $60 to find the problem. According to the technician problem was control board and cost of labor and parts $465.00
Jumped on Part Select website, placed a question with my stove problem through the chat. Immediately they answered my question and told me the problem was the Terminal Block. Cost of part and shipping $25.00. Replaced it myself and everything works fine.
Thank you, Thank you Part Select for your help and honesty.

Sincerely
Peter from Maryland
Parts Used:
Terminal Block
  • Peter from FREDERICK, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers, Socket set
7 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
electric coils would not stay flat as drip pans were incorrect fit
replaced drip pans with correct type
Parts Used:
Chrome Drip Bowl - 8 inch Drip Bowl - 6 Inch
  • Janet from Philadelphia, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 653AJ-V-CX
1 - 15 of 102
Back to Top