3510PRW Magic Chef Range - Instructions

Removed heating element, installed new drip pan, replaced heating element. Was amazed at fast delivery - ordered in afternoon, arrived fed ex next morning!

I followed a video on google and once I shut the power off, it took me less than 15 minutes to fix. Saved me atleast $30.00 for a Home Warranty Serv. Charge.

New receptacle element. I am a girl and I did it.!!!!

Opened box took out part installed on 5 minutes easy as pie

Removed two screws on each end of the bottom element, removed blade wires from element and removed element. Put new element in to place in oven, put blade wires on to end of element and put in the two screws that held the element in place. Watched and followed the video instructions on the website. Very easy to repair.

When we received the new element for the oven. We followed the directions that where given to us and had no problem installing the new element. It took no time before the the oven was working again. thank you for posting the directions to make the job go easier.

Was easy cut the wires of as told to do wire nut the ends together and put back together and tested and worked great. Done

I followed the instructions given on your great site. Thank you so much.

Disassembled upper unit with Phillips screwdriver. Removed 2 "plug connectors" from element switch. Replaced switch. Plugged both connectors back onto switch. Reassembled the upper portion of the range. Tested and OK

Remove heating element coils. & old drip pans. Install the new drip pans and reinsert the heating elements and insure all elements were level. For aesthetic reasons I replaced all the drip pans - 2 x 8" & 2 x 6".

KILL POWER FIRST. I should have read other entries on here prior to starting. I would have learned that one leg of the element is always hot. Fortunately it arced against the oven, and all I had to do was replace the terminal. Could have been much worse. Unplug range or shut off circuit breaker prior to doing any electrical work. Verify 0 voltage before starting if you shut off the breaker.

During normal use, the heating element on my electric range burst into flames one day. Judging from the internet, this is actually fairly common! It's an electrical fire, so it's important to shut the oven off at once, and not a bad idea to cut the circuit breaker immediately. Then put the fire out and unplug. Remove what's left of the old element by unscrewing 2 mounting screws where it enters the oven rear wall. Taking door off of oven made it easier to lean in there. Then pull the crimp connections apart to get the wires off of each end. There are videos on youtube and partselect.com showing how. One thing they don't mention is that the wires may want to disappear back into the hole in the oven wall once they're loose. So hang onto them. I put a piece of duct tape around each one to keep it from slipping back into those small holes. When the new element arrived, I just reconnected the two crimp connectors and re-mounted the two screws. Of course, make sure range is unplugged while you're in there. Those two wires have 220V on them. I'm also never again going to leave my range on, either in baking or cleaning mode, when I'm not home. That fire was scary!

just removed two screws installed the unit replaced the two screws

Turned off circuit breaker to oven. Removed old unit by undoing screws and remove from clamp.Put to unit in by placing it to clamps and adjusting so it was level and screwed it back in. Voila! But now I think I need a sensor..

My husband did it and was very easy. Has been done before too. Very fast service from you also. Will order again if we need to.