31000PAW Magic Chef Range - Instructions

snaped them into oven cavity attached temp bulb job complete

I just pop on the new knob. It was easy. And I got fast service order my knob and it got here in 3 days. I am very happy with your part and service. Thanks Donna Eden

Made sure the knob was in the Off position.
Removed the old knob by gently pulling it off.
Lined up the knob and pushed it on.

This is a no brainer. I am only doing this because you asked. Pull out the stove, tilt it back, remove broken leg, install new leg.

I tried to get black drip pans to replace the ones I had which were well in need of changing. They no longer make the black so I found the silver ones on your site and thought for the price I would try them. They are wonderful and very reasonably priced. I ended up buying a spare set for later. Thank you for such great products and prices.

Pushed on new knob. I was concerned temp markings would not be accurate so I purchased an oven thermometer. The markings were accurate to actual oven temp at 350 degrees so I am very happy with the replacement part. Thank You.

My used stove had been dropped by the previous owner. While I could live with the minor scratches on one side the wooden shims holding up one corner were annoying. A new leveling leg was less than $2. I used a pair of needle nose pliers to straighten the mounting hole and screwed the new leg in. This used stove was originally $2000 but I bought it for $999. the new leg plus shipping was about $10. What a deal.

The range in my classroom had the leveling legs broke off by the summer staff. I ordered two new leveling legs and the night custodian replaced them in about 45 minutes and them leveled the stove. Parts were just as stated and easy to order.

I was pleasantly surprised that the knob I ordered from you was perfect. Your catalog picture/description was right on. I am so grateful I found your site. I looked @ others and they did not compare to your thorough description. Thank you.

Broke the same day I installed it

Pushed the knob on to the part that was sticking out. Knob fit perfectly...had to use a substitute part & wasn't sure it was the right part, so was pleasantly surprised!

Shut off the gas before you do anything! Remove the top front face cover by removing the four screws. Remove the three gas lines that go into the oven valve. remove the screws that hold down the manifold bar. Slide bar to the front and free from the burners and main valve. Remove the small bolt on the underside of the manifold that holds in the oven valve to the manifold. Remove old thermostat bulb from it's bracket inside the oven and pull through to the top of oven. Then remove the old valve. Remove rubber seals and transfer them to the new valve if you don't have new ones. Replace the new valve. Insert thermostat bulb on the end of the wire into the hole and down into the oven. Mount thermostat bulb into bracket. Then just reinstall in the same order that you took it apart. Then run the oven and check the new thermostat out to make sure it is working properly.

finished removing door seal, used pliers to remove old securing studs. positioned new seal and pushed securing studs into existing holes and was done.

Removed old knob and took new knob out of package and just slipped it on the stove. Less than a minute.

I couldn't find my model number U31EA-7 so I decided to go with a deferent model number U31FA-7 Pulled the old Knob off and pushed the new knob on and it works great