24AD597D766 (LS33T 2008) Troy-Bilt Log Splitter - Overview

Self-Tapping Screw, 5/16-18, .750 Add to cart

Nut, Flange Lock, 5/16-18, Grf This nut is a manufacturer-approved replacement part for various lawn and garden equipment. It is sold individually, not as part of a kit or assembly. Also referred to as a Lock Nut, it is resistant t... Add to cart

Nut, Flange Lock, 3/8-16, Grf Designed for use in various models of lawn and garden equipment, this part is not sold as part of a kit or assembly. It is made of metal, is gold in color, and is sold individually. This part may also... Add to cart

Spider Bushing This rubber and plastic spider bushing is a genuine OEM part for various makes of log splitters and is sold as an individual part. Measuring at approximately 2-inches by 2-inches, this bushing is atta... Add to cart

Bell. Wash. .340 I.D. x .872 O.D. Sourced directly from the original manufacturer, this Bell Washer is made of gold-colored metal and is sold individually, not as part of a kit or assembly. It is used to provide spacing between variou... Add to cart

Adjustable Gib

★★★★★

★★★★★

(1)

The Adjustable Gib (Keyway) is a gray, metal, 2 inch, individually sold part rated as easy to install by consumers. It locks two shafts together so they can rotate. You will know if you need to repl... Add to cart

Push Cap The Push Cap is a black plastic cap which secures to the end of a shaft to prevent injury. It can be installed with a hammer and is rated as "Easy" to install. If the part appears damaged or worn down... Add to cart

Coupling, .500 This coupler connects the engine or motor to the hydraulic pump in your lawn equipment. It has a 0.5-inch inside diameter and is typically located near the rear coupling support bracket. If the couple... Add to cart

Hub Cap This OEM Hub Cap, or Dust Cap, is a 2-inch, silver, steel part, sold individually. It requires a Rubber Mallet to install and its installation is rated as Easy by our customers. This part attaches i... Add to cart

Spark Plug Add to cart

Back Plate This back plate, also known as a wedge plate, is sourced directly from the manufacturer for use in log splitters. It is a flat, metal plate found at the rear end of the machine, with a length of 8 inc... Add to cart

Coupling, .875 Add to cart