All Installation Instructions for 2035

light wont come on

Well, when you put the back cover on and screw it down make sure you have nothing touching the white wire leading to the oven light. I did and it blew the push switch when I threw the 220 breaker. Actually, the light was on when I came in the room, but when I pushed the switch on the front panel it sparked in the rear and popped the breaker. Then I saw the short and when I tested the switch it would not click. The install was fine.

Parts Used:

SWTCH-LITE

James from Fort Collins, CO
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers, Wrench set

4 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

The hub that the mower blade mounts to was broken

The hub that the mower blade mounts to was brokenPut the new Harbonne played and played securing flange bolted it up

Parts Used:

Spacer-Driver

Blade Driver Assembly

randy from HIGHLAND, IL
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench set

6 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

drive cable broke

removed the broken cable and installed the new cable,

Parts Used:

Cable-Traction

Donald from MARION, IA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set, Wrench (Adjustable)

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dull blade

Disconnected spark plug wire laid lawn mower in side removed blade bolt took off old blade put new blade on tightened it reconnected spark plug wire

Parts Used:

Blade, 20 Inch

Robin from BIRCH RUN, MI
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Leaking gaskets

All the gaskets needed to be replaced on the Briggs 6.75 flathead I was rebuilding. I ported and polished the ports and shaved the eyebrow between the valves and the piston. The gasket set was a perfect fit. It is a monster now. It doesn't sound like a lawnmower engine anymore

Parts Used:

Engine Gasket Set

Dustin from BANGOR, ME
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Socket set, Wrench set

3 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

trailing shield had broken off the mower, rendering bag useless.

Removed the wheels, attached the shield and replace wheels. Easy-peesy!

Parts Used:

Trailing Shield

Judy from PRINCETON, MN
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Wrench (Adjustable)

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Wheel height adjuster lever (spring steel) cracked / split in two.

Tip mower onto side, raising side to be repaired. Empty gas tank if possible or use rags to prevent gasoline drips onto clean surfaces.

Remove wheel using a 1/2" socket.
Remove wheel height assembly with 1/2" socket and open end wrench to hold nut below the deck.
Position new spring arm over the slot on wheel height assembly plate. Check opposite side to verify correct orientation if needed.
Remove plastic cover from old lever using a small flat blade screwdriver. Slip onto new lever.
Replace wheel height assembly.
Replace wheel.

Parts Used: