Models > 135202 > Instructions

135202 ((0271-01)) Briggs and Stratton Engine - Instructions

All Instructions for the 135202
1 - 4 of 4
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Wouldn’t start.
I installed a new solenoid starter. Took me a total of 20 minutes. Started right up.
Parts Used:
Solenoid-Starter
  • Bruce from CARNATION, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
6 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
5 HP Briggs and Stratton chipper shredder - no spark
Removed old sparkless magneto, replaced with new part PS9278124 Magneto, and still no spark. The only conclusion that I can draw, is this magneto is defective,
Parts Used:
Magneto
  • Thomas from ALFRED, ME
  • Difficulty Level:
    Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
no gas to carb
pulled off fuel pump cover ,cleaned surfaces. Applied gasket sealer and replaced fuel pump diaphragm.
Parts Used:
Diaphragm-Carburetor
  • Dennis from MUKWONAGO, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Generator would not start, Birggs & Stratton recommended to replase Gasket Exhaust.
Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket.
Parts Used:
Gasket- Exhaust
  • Alberto from PALMETTO BAY, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Socket set
2 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 135202
1 - 4 of 4