135202 ((0304-01)) Briggs and Stratton Engine - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
5 HP Briggs and Stratton chipper shredder - no spark
Removed old sparkless magneto, replaced with new part PS9278124 Magneto, and still no spark. The only conclusion that I can draw, is this magneto is defective,
Parts Used:
-
Thomas from ALFRED, ME
-
Difficulty Level:Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers
10 of 15 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
no gas to carb
pulled off fuel pump cover ,cleaned surfaces. Applied gasket sealer and replaced fuel pump diaphragm.
Parts Used:
-
Dennis from MUKWONAGO, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
10 of 15 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wouldn’t start.
I installed a new solenoid starter. Took me a total of 20 minutes. Started right up.
Parts Used:
-
Bruce from CARNATION, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
10 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old diaphragm dried up
Tore carburetor off leaf blower and replaced. To do that require taking off the air cleaner removing the gas tank and all the brackets holding the controls on it. And keeping track of all the screws and Wires that control choke and throttle. I took several photographs. I did not need all the gaskets and jet’s that were included in the kit but it had what I needed.
Parts Used:
-
Steven C from CENTREVILLE, MI
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
5 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Generator would not start, Birggs & Stratton recommended to replase Gasket Exhaust.
Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket.
Parts Used:
-
Alberto from PALMETTO BAY, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set
7 of 23 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!