12-2299-00-01 Tappan Wall Oven - Instructions

took off door, oven floor and burner cover. cut the wire for the old igniter and used ceramic nuts (provided) to hook up the new one. screwed the new one on with old screws, tested and re-assembled. Saved a hundred bucks easily, but I have some basic electrical back ground.

First, I took out the racks. Then I removed the bottom cover of the stove. (This was in place by two screws that I used my drill & socket set.) Next, remove burner cover by a socket set. Finally, in the corner was a metal cover that covered part of the electrical connections. I then used the screw driver to undo the screws that attached the igniter to the oven. I undid one wire connection, and wired it with the new one on the igniter. (To make sure I wired it correctly.) Then I undid the other wire, and connected it with the new wire (using the new wiring nuts provided.) Done! Now just put all the parts back together.

After reading the input of others on your site I ordered the igniter. Within a short time it was installed and the oven works fine. Thanks for the help, jc

First i disconected the plug went right where the trouble was.removed the two screws and the safe plate that is protecting the wires.disconeted the two wires and replaced the new ignighter. put everythin back together tried it out ond guess what ??? it works .. Thank you

Easy as 1-2-3

Removed the oven racks. Unscrewed the two screws that held the oven bottom in. Removed the burner shield (one nut to remove). Removed the two screws holding the igniter in place. Removed the wires from behind and attached to the igniter. Removed the cover from corner that shields the wire and plug. Removed the plug. Removed entire igniter assembly. Cut and stripped the wires and wired back to the ends by using the wire nuts provided with the new igniter. Then just reversed the steps to reinstall the igniter! Yaay! It works fine. And I am a 66 year old woman with no help! I was very happy with the service and instructions provided by PartsSelect! Thanks!

Replaced the oven igniter by removing the bottom oven tray (2 screws at back). Removed the 2 bolts that hold the igniter in place and cut the cables to it. Cut a little cable off the new igniter (cable supplied on the new igniter is long). Attached the new igniter with the 2 bolts and connected the cables together using the ceramic cable connectors supplied. Only thing to take care with is that you do not cut the cables too short and make sure to leave enough of a loop to join the cables together.

had to cut to make a three end so it would plug in all three places

Really a no brainer, but I do have to say that PartSelect customer service is excellent. My part was located and on it's way within a day and arrived a couple of days later.

My mom did the repair for me. We did not have the right tools for the job which made it harder to do. First I flipped the breaker. Then we took out the oven racks. We then took the bottom metal part off the oven. This exposed the shield part and we removed it. Then she cut the wires and connected the new igniter the same way the old one was connected. It took about thirty minutes. We could do it again in about fifteen with the right tools. We went and priced new stoves the cheapest was 350.00. I'm so excited that my stove is working properly again.

Removed interior sheet metal to expose ignitor. Removed two nuts holding ignitor to braket. Cut wires. Attatched new ignitor, replaced sheet metal and baked a pizza.

Took everything apart and replaced

Removed covers, disconnected old igniter, spliced the new and replaced. The oven fired up as hoped!

Cut the wires and replace new ignitor very simple

Aging igniter glows but does not draw enough current to open the gas valve. Replaced igniter and it is working properly now.