Maytag Dishwasher Wheels and Rollers | Replacement Parts & Accessories | PartSelect

Popular Maytag Dishwasher Wheels and Rollers

Your Price
$33.22
Dishwasher Lower Dishrack Wheel Assembly - Gray
PartSelect Number PS11722152
Manufacturer Part Number W10195416V
The lower dishrack wheel is used in a dishwasher to easily roll the dishrack back and forth on the rails. To repair, open the dishwasher door and pull out the lower dishrack. Next, push the tab from both sides and it should pop out. To install the new wheel assembly, place it on the rack and make sure the caps overlap the wire from the inside before you clip it in place by pushing the wheel. Slide the rack back in the dishwasher to make sure it is installed correctly. Refer to the manual provided by the manufacturer for further instructions.
Fixes these symptoms
Door latch failure
Door won’t close
Noisy

See more...
Installation Instructions
Thomas from WEST OLIVE, MI says,

Broken wheel unit on the bottom dish rack
All you do is pop out the old wheel unit at two (2) points on the plastic wheel housing and pop in the new one. Easy fix. Less than a 5 minute fix....read more

Your Price
$7.33
Upper Rack Wheel and Mount Assembly
PartSelect Number PS11745525
Manufacturer Part Number WP8270019
Sold Individually.
Fixes these symptoms
Not cleaning dishes properly


Installation Instructions
Kevin from Hurst, TX says,

top dw rack fell off of rollers
Amazingly, this not-too-old dishwasher's plastic parts that hold the top rack onto the sliders became brittle (a real design flaw, in my opinion) and the tabs that held the rollers in place all broke ...read more

Your Price
$9.84
Lower Wheel Assembly
PartSelect Number PS11747757
Manufacturer Part Number WP99003149
The lower wheel assembly in your dishwasher allows the lower dish rack to roll in and out effectively. If you notice that one of the dish rack wheels is damaged or missing, this is the part you will need to replace it. This part consists of the wheel and axle or clip that holds it on the dish rack. This wheel assembly is sold individually. This lower wheel assembly is made of plastic, is gray in color and the wheel itself is approximately 1 and 3/4 inches in diameter. Many of our customers have rated this repair as easy. To complete this repair, simply remove the old wheel assembly, and snap the new one into place.
Fixes these symptoms
Noisy
Not cleaning dishes properly


Installation Instructions
Kathryn from Oak Creek, CO says,

One of the wheel assemblies fell off and melted in the dishwasher.
I ordered the part and snapped it on. It was so easy to find the part on the website and it came very quickly. I am a satisfied customer!...read more

Your Price
$6.92
Rack Adjuster
PartSelect Number PS11750255
Manufacturer Part Number WPW10204131
Sold Individually.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Randy from Glenview, IL says,

Replacement of broken Rack Assembly Mount with Wheel
The only piece that may be a little difficult to remove here without a tool is the 'Track Stop'. This piece has a couple of clip-like pieces that need to be depressed in order to remove it. A flathead...read more

Your Price
$9.80
Upper Rack Wheel
PartSelect Number PS11747755
Manufacturer Part Number WP99003147
Sold individually.
Fixes these symptoms
Door latch failure
Door won’t close
Noisy

See more...
Installation Instructions
Anthony from Greenwich, CT says,

Replace wheel
Tghe old one snaps off and the new one snaps right in ....read more

Your Price
$7.08
Lower Wheel Assembly
PartSelect Number PS11747717
Manufacturer Part Number WP99002780
This lower dishrack roller is less than two inches in diameter. It is made entirely of white plastic. If you find that your dishwasher is making loud noises or the lower rack is getting stuck when you are moving it in or out, it could be that the lower wheel assembly needs to be replaced. The dishrack wheels allow for easy movement of the dishrack in and out of the dishwasher. These rollers tend to wear down at the same speed, so it is recommended to replace both pairs at the same time. Open your dishwasher and remove the bottom rack, locate the locking tab, and rotate until it easily slides out of place. Slide the new wheel over the shaft and locate the locking tab to snap back into place.
Fixes these symptoms
Noisy
Not cleaning dishes properly


Installation Instructions
Walter from Tucson, AZ says,

Broken latch handle
The hardest thing was figuring out that you only need to purchase the latch handle because it only comes as a complete latch assembly, why they even list the latch assembly as a separate part in the p...read more

Your Price
$17.81
Dishrack Adjuster and Wheel Assembly
PartSelect Number PS11756470
Manufacturer Part Number WPW10571738
This dishrack adjuster and wheel assembly is for dishwashers and lets you adjust the dishrack height and attaches the track wheels to the dishrack.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Jeffrey from SKOKIE, IL says,

!
Watch a few YouTube videos, they show very simple tricks to unlock the plastic parts before your installation...read more

Your Price
$6.43
Upper Wheel Assembly
PartSelect Number PS11747756
Manufacturer Part Number WP99003148
This part attaches to the upper rack to help the dishrack to move in and out along the track of the dishwasher smoothly. If your dish rack is not moving in and out of the dishwasher properly or with ease, you may have a broken or missing roller and it will need to be replaced. The roller and axle are made of plastic, are a little over an inch in size, gray in color and sold individually. This is a genuine OEM kit.
Fixes these symptoms
Door won’t close


Installation Instructions
Donna from West Newbury, MA says,

A couple of wheels fell of and melted in the dishwasher.
I used to love my dishwasher, but the top shelf was hanging and the bottom rack kept getting hung up. I was helping clean up at a friends house and was very envious of how nice her dishwasher was work...read more

Your Price
$6.95
Dishwasher Dishrack Roller
PartSelect Number PS11755768
Manufacturer Part Number WPW10505748
This is a tub wheel assembly for your dishwasher. This assembly, complete with two rollers on a supporting bracket, supports the rack along the upper rail or track to allow the rack to slide smoothly. You may need to replace this if the rollers are broken or jammed. The part is gray in color and is made of plastic. You will need to remove your upper rack to install this replacement tub wheel assembly.
Fixes these symptoms
No Symptoms for this part
Your Price
$33.29
Lower Dishrack Wheel
PartSelect Number PS11751413
Manufacturer Part Number WPW10261335
Sold individually.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
mary from LA GRANGE PK, IL says,

dish rack wheels plastic broken
just replaced broken piece ,,,, very easy ,,, will use you again for parts should the need arise...read more