Magic Chef Refrigerator Motors

Magic Chef Appliance Parts
Shop By Part Type

Popular Magic Chef Refrigerator Motors

Your Price
$48.00
  In Stock
Condenser Fan Motor Kit
★★★★★
★★★★★
(23)
PartSelect Number PS395284
Manufacturer Part Number 833697
This condenser fan motor kit is designed for use with refrigerators. This fan draws air through the condenser coils and over the compressor. It does this with the goal of cooling the warm refrigerant before it enters the evaporator. When your fan or fan motor is not working your refrigerator will not cool properly. This is a 2-Watt, 115 Volt motor that rotates the fan in a counter clockwise direction. This kit includes the hardware needed for installation, and a set of instructions. Before you begin any repair work make sure to unplug your appliance.
Fixes these symptoms
  • Freezer section too warm
  • Fridge and Freezer are too warm
  • Fridge runs too long
  • See more...
Installation Instructions
Tom from Franklin, WI
Sometimes the condenser fan would start causing the refrigerator to overheat.
Unplug the appliance.
Removed the screws holding the back panel.
Removed the fan blade.
removed 3 screws holding the condenser fan.
Remove the 3 metal brackets attached to the fan.
(First note which studs the brackets are attached to. Attach the 3 metal brackets to the new fan. (New screws were supplied)
Cut and strip the wire about two inches from the fan.
Cut and strip the new wire. I cut the new wire in half (about 6 inches.) Connect the two wires, twist and used 2 wire nuts. Tie wrap the wire to the wire harness. Mount the new fan (three screws)
Screw the back panel back on.
Mount the new
Read more...
Your Price
$71.49
  In Stock
Evaporator Fan Motor - 60Hz 120V
★★★★★
★★★★★
(19)
PartSelect Number PS11749890
Manufacturer Part Number WPW10189703
This is a 60 Hertz, 120-volt evaporator fan motor for your refrigerator. This part is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. The most common reason for needing to replace the motor is if the temperature in your freezer and fridge are inconsistent, or there is no air circulating at all. You will need a quarter inch nut driver and a pair of needle nose pliers for this repair. Note: This motor uses 2 brackets, which are sold separately.
Fixes these symptoms
  • Freezer not defrosting
  • Freezer section too warm
  • Fridge and Freezer are too warm
  • See more...
Installation Instructions
Brian from Smock, PA
Fridge was warm. No air circulating at all. Food was spoiling Fridge was just over 1 year old
First I removed the two screws that secure the guard in bottom back of the freezer and removed it . Next I removed the two screws that secure the guard on the back wall of the freezer and removed it. There are three wires connected to the motor, I unplugged those and removed the two screws that secure the motor and removed it. I swapped the grommets, blade and support bracket from the old motor. I put it back together in reverse steps and its working great. My mother-in-law can,t stop thanking me ! I saved her at least $400 to buy a new fridge. Thank You, Brian Miner Read more...
Your Price
$63.48
  In Stock
Freezer Evaporator Fan Motor - 115V 60Hz
★★★★★
★★★★★
(5)
PartSelect Number PS11748697
Manufacturer Part Number WPW10128551
This is an evaporator fan motor, it is 115 volts and 60 hertz and it is for your refrigerator/freezer. You will need to replace this part if your appliance is too warm or getting noisy. This evaporator fan motor is located in the back of the freezer. This part circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated throughout your appliance. To replace this part you will need a 1/4-inch nut driver and a pair of needle nose pliers.
Fixes these symptoms
  • Freezer section too warm
  • Fridge too warm
  • Noisy
  • See more...
Installation Instructions
jarrett from PALM DESERT, CA
refrigerator not cold but freezer was cold
removed ice maker and wire shelf. removed back panel screws and tilted forward. removed 2 screws holding motor bracket. swapped fan blade and reassembled Read more...
Your Price
$118.28
  In Stock
Condenser Fan Motor
★★★★★
★★★★★
(4)
PartSelect Number PS11739140
Manufacturer Part Number WP2188874
This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Please note: If the original fan motor has 3 terminals please order part number W10204250, otherwise order this part (WP2188874).
Fixes these symptoms
Your Price
$69.22
  In Stock
Evaporator Fan Motor
★★★★★
★★★★★
(2)
PartSelect Number PS11749867
Manufacturer Part Number WPW10188389
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
Fixes these symptoms
Installation Instructions
Donald from Waco, TX
The freezer section was working fine. Not properly cooling the refrigerator
I looked on line to see what was causes of the problem and determined that it was probably the fan in the freezer not working. I took the back section of the freezer apart and saw the fan was not running. I checked the parts on line and found that it was availiable and ordered a new fan motor. The blade looked fine, but I ordered a grommet anyway to ensure that there was no vibration problems causing the fan motor to go out. When the fan motor arrived, I began disconnecting the old one after unpluging the refridgerator and noting the terminals for the wires. The wire terminals were in a slightly different location, but reasoned out which wire belonged to the correct location. I pulled the old fan motor out, switched out the fan blade and grommet and re-incerted the new fan motor. I reconnected the wires and re-assembled the rear wall of the freezer. I plugged in the refridgerator and wa-la! It worked. Read more...
Your Price
$83.31
  In Stock
Evaporator Fan Motor - 115V 60Hz - Blade NOT Included
★★★★★
★★★★★
(2)
PartSelect Number PS11743214
Manufacturer Part Number WP61004888
This is an evaporator fan motor for a refrigerator. The fan motor circulates air through the refrigerator to the fresh food compartment for efficient cooling. It is just over three inches long. It is made of both metal and plastic, and is made up of black, white, and metallic pieces. Disconnect power from your refrigerator before starting the repair because you will be working near electrical circuits. This is an authentic replacement part that is sourced directly from the original manufacturer. It is important to note that the blade is sold separately and is not included with the evaporator fan motor.
Fixes these symptoms
  • Freezer section too warm
  • Fridge too warm
  • Noisy
  • See more...
Installation Instructions
Robert from Brunswick, GA
Side by side refer. Refer side not cooling enough
Fan motor was blowing air and was confusing but replaced motor and found that it was not blowing enough. It took two screws in the freezer side to expose the evaporator and it's fan. The fan slides out after disconnecting three wire plug ins and then the motor can be swapped. Read more...
Your Price
$145.26
  In Stock
Condenser Fan Motor
★★★★★
★★★★★
(1)
PartSelect Number PS11743226
Manufacturer Part Number WP61005323
This fan motor is most times used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This fan motor also helps to evaporate excess water in the drain pan.
Fixes these symptoms
Installation Instructions
Gray from Gilead, ME
I pulled the fridge out to vacuum the coils and noticed the fan was not working
First I removed the cardboard cover, which was held in place by 7 screws. Actually first I unplugged the fridge, next using a nut driver I removed the 3 screws holding the supports to the motor. The motor with fan just pulls right out. Next was to disconnect the wire harness or plug, which required squeezing together the plastic plug and moving it side to side while gently pulling.
With motor in hand using a pair of pliers remove the poor excuse for a nut of the fan motor shaft holding on the fan. Slide the fan off the shaft -note direction of blades!!!! Using a nut driver remove 2 srews holding on the plastic motor support . This slides right off the back. To assemble follow the reverse . Just check to see that the fan spins freely before plugging back in your fridge.
Read more...
Your Price
$143.24
  In Stock
Evaporator 4-Wire Fan Motor
★★★★★
★★★★★
(1)
PartSelect Number PS11743228
Manufacturer Part Number WP61005339
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
Fixes these symptoms
Installation Instructions
Peter from San Jose, CA
Fridge not cooling
The fridge wasnt cooling and freezer was barely operating. We had the same problem in 2005 and the fan that blows cold air into the freezer and fridge was replaced for $200 BY Maytag. We looked up the part and found two choices with different connectors but narrowed it down by the pictures and series #. The part was ordered Sunday and arrived Tuesday for ~80$. To intsall you simply remove food and shelves then 4 nuts that hold back pnael in place. Then release one wiring harness connector to allow the panel to pivot out. After that you can easily release the clips holing the fan cover and then undo two screws to drop assembly out. Two more screw release fan body (you can reuse the fan blade) and one more for the earthstrap. After that follow reverse instructions to reassemble and after ~45 mins the unit was as good a new. Having said that there seems to be a basic design flaw in this maytag unit if fans only last 3-4 years. Still much cheaper than buying a new fridge. Read more...
Your Price
$147.32
  On Order
Ice Bucket Auger Drive Motor Kit
PartSelect Number PS2003313
Manufacturer Part Number 12001773
This motor kit comes with a thermally protected motor, a washer and a mounting bracket. The motor performs eighteen revolutions per minute, carries 115 volts, and drives the auger for the icemaker.
Fixes these symptoms
Installation Instructions
Walter from Woodbridge, VA
Quick and Easy Install of Ice Maker Parts
Several days back I found I couldn't get any ice from the ice maker. I was able to hear noise from the ice maker but no ice would dispense. I opened the freezer and removed the ice bucket to find out that the Auger has broken off from it's plastic housing in the back of the freezer. I went to partselect.com to find the part(s) that were broken, it was much easier because of the diagram/images they have for each individual section of the fridge. Parts came quickly and as expected.

The replacement of the auger motor is very easy if you follow these steps:

1 - Remove the ice bucket from the freezer
2 - Unscrew the one screw on the bottom left side of the ice bucket tray (the tray holds the ice bucket in place). I used a small needle nose plier to remove this screw as I was having a hard time with my drill or wrench set. After you've removed the one small screw, lift the tray up and slowly pull towards you.
4 - You'll quickly see that the auger motor and magnetically controlled yoke are connected with a wire harness to the back of the freezer.
5 - Gently crimp the ends of the wiring harness connector with your hand and slowly pry away from the freezer. Once you've removed the wiring harness you can remove the entire tray with the parts attached (yoke/auger)
6 - Unscrew the auger motor from the tray. You'll also have to remove the auger from the motor else it won't come out. In my case the whole plastic attachment was broken so I didn't have to do this (ie I replaced the ice tray as well). It was impossible for me to remove the auger from the auger motor, not sure why the auger was so tightly attached to the motor - it could be the reason the auger motor broke from the ice tray?, so I had to buy a brand new auger motor and auger (ie Auger Drive Motor Kit). I hope you have more luck then I did removing the auger. If you can't remove it you'll need to buy the Drive Motor Kit (which comes with the drive motor, detached auger and auger washer).
7 - Once/if you've removed the auger from the motor and remove the motor from the ice tray, you can proceed with the replacement of motor.
8 - Using needle nose pliers remove the three power connections on the motor (white/neutral?, pink/power?, green/ground, note where the connections were when you removed them because you'll replace them in the same place on the new motor).
9 - Attach new motor to ice tray with the four screws, attach the auger and auger washer to the auger motor, attach the power connections back (white, pink, green).
10 - Re-connect the wire harness to the back of the freezer
11 - Move ice tray back into place, and attach the one screw back to the ice tray to hold it in place.
12 - Replace the ice bucket back onto the ice tray
13 - Done, you should now get ice!

Good luck, I hope this helps. It's easy and you don't have to pay three times this price to replace these ice bucket parts.
Read more...
Your Price
$178.37
  In Stock
Auger Motor
PartSelect Number PS11743528
Manufacturer Part Number WP67003226
This part rotates the auger to dispense ice.

Related Parts