Kelvinator Dishwasher Seals and Gaskets

Popular Kelvinator Dishwasher Seals and Gaskets

Your Price
$21.06
  In Stock
Kelvinator Dishwasher Bottom Door Gasket
★★★★★
★★★★★
182 Reviews
PartSelect Number PS9495545
Manufacturer Part Number 809006501
This dishwasher door gasket (Bottom Gasket, Gasket, Door Seal, Dishwasher Door Lower Seal) helps prevent water from leaking out of the bottom edge of your dishwasher door by creating a watertight seal. This part is attached to the bottom of your dishwasher inner door panel. It is frequently exposed to water and detergent during its lifetime. The water and chemicals can eventually wear down the gasket and compromise the integrity of the seal. If the gasket is malfunctioning, the integrity of the door seal will be effected. You will notice leaking through the bottom of your dishwasher door. If your dishwasher is leaking water from the bottom of the door, first inspect the seal for food particles near the bottom and sides, and remove the buildup, as it can stop the door from closing properly and keeping a tight seal; if not, you may need to replace the bottom door gasket. Check the door gasket for tears, cuts, or wear. This part is sold individually and measures 22.5 inches by 1.25 inches. It is constructed of plastic, and comes in yellow/grey. Includes one lower door gasket.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Leaking
  • See more...
Installation Instructions
Scott from Flowood, MS
Bottom Door Seal fell apart and started leaking.
First I opened the door all the way. Second I reached down to the bottom gasket then grabed it on the right end of the seal that is on the right side of the door. Then I pulled the end outward from the bottom of the door toward the heater coil in the bottom of the washer. It came out real easy. You see it just snaps into a little plastic groove under the door. I then cleaned up the area for food and soap particules. I then placed the new gasket in place by lining up the notch toward the right end with the piece of plastic that encloses the right end of the plastic notch on the bottom right end of the door. Then push it in untill it stops going into the notch. It snaps in but does not make a snaping sound. It just won't go in no more. Read more...
Your Price
$32.35
  In Stock
Kelvinator Dishwasher Tub Gasket - Gray
★★★★★
★★★★★
42 Reviews
PartSelect Number PS8260227
Manufacturer Part Number 154827601
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing water leaking out. If broken, it should be replaced. Refer to your model number and user manual to ensure this part is right for you. When making this repair, open the dishwasher door and take out the lower dish tray for better access. Pull out the old gasket, and clean the channel with a rag. Push the new gasket into place into the notch on the door, which you should see upon close inspection, using a flat-head screwdriver for assistance if necessary. We do not recommend cutting any additional length off on the tub gasket if any is present during your repair.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Leaking
  • See more...
Installation Instructions
Charles from Milton, FL
dishwasher was leaking water
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in. Read more...
Your Price
$39.42
  In Stock
Kelvinator Dishwasher Splash Shield Kit
★★★★★
★★★★★
9 Reviews
PartSelect Number PS2203346
Manufacturer Part Number 154701001
This splash shield kit is used in dishwashers and is attached to the lower front corners of the tub. The splash shield is used to prevent water from spraying past the door seal. If your dishwasher is leaking from the corners of the door gasket, replace this part. For this repair, the only tool needed is a flathead screwdriver. The measurements of this part are: 1.50 inches in length, 0.50 inches in width, 1.70 inches in height. It weighs 0.10 pounds. Remember to unplug your appliance from the power source as a safety precaution.
Fixes these symptoms
Installation Instructions
Sandra from DAYVILLE, CT
Leaky on bottom right
Pulled out old gasket and shield guards and put in new ones. No tools needed. Piece of cake?? Read more...
Your Price
$10.60
  In Stock
Kelvinator Dishwasher Delivery Tube Gasket
★★★★★
★★★★★
1 Review
PartSelect Number PS421211
Manufacturer Part Number 154406401
Sold individually.
Fixes these symptoms
Installation Instructions
Mary from Alexandria, VA
Upper spray arm had been "blowing off" during wash cycle.
Unscrewed retaining ring, replaced unit = piece of cake Read more...
Your Price
$44.87
  In Stock
Kelvinator Dishwasher O-Ring - Rear
PartSelect Number PS420466
Manufacturer Part Number 154246901
Fixes these symptoms
Installation Instructions
John from Herndon, VA
replaced dishwasher motor
Single-handedly. Tipped dishwasher on its side for easy access to water and electric connections. Went back together with no problems or leaks, washes quiter than ever. Read more...
Your Price
$44.87
  In Stock
Kelvinator Dishwasher O-Ring - Front
PartSelect Number PS420467
Manufacturer Part Number 154247001
Fixes these symptoms
Installation Instructions
John from Herndon, VA
replaced dishwasher motor
Single-handedly. Tipped dishwasher on its side for easy access to water and electric connections. Went back together with no problems or leaks, washes quiter than ever. Read more...
Your Price
$60.42
  In Stock
Kelvinator Dishwasher Sump Gasket
PartSelect Number PS420465
Manufacturer Part Number 154246801
Fixes these symptoms
Installation Instructions
Greg from Rockwall, TX
Replace sump gasket
#1 rule, make sure you valve off the water before removing any hoses. Remove wire trays inside dishwasher and then pull out dishwasher far enough to disconnect water line and power cord. Remove center piece and screen covering sump inside the dishwasher. Turn dishwasher on its side and remove hoses to sump and pump. Disconnect power to sump pump. Loosen retaining nuts that secure the sump and remove. Replace old gasket on sump with new. Turn dishwasher upright. Be careful with placement of new gasket when reinserting sump so that the gasket doesn't come out of position and the sump is centered properly. Secure with retaining nuts from bottom. Reconnect power connector and hoses to sump. Pour enough water into the dishwasher to verify gasket doesn't leak... look with flashlight under dishwasher for signs of water dripping from sump. Reinstall screen and centerpiece in sump inside the dishwasher. Reconnect water line and power cord. Run through wash cycle while monitoring for leaks under dishwasher. Reinstall wire trays.

Piece of cake as long as you get the gasket installed properly and the sump centered correctly... do not overtighten the retaining nuts or it may force the gasket out of position when the screen is secure with the center locking piece over the sump.
Read more...
Your Price
$33.30
  In Stock
Kelvinator Dishwasher GASKET
PartSelect Number PS1148936
Manufacturer Part Number 154553501
Your Price
$2.27
  Special Order
Kelvinator Dishwasher SEAL
PartSelect Number PS411882
Manufacturer Part Number 08007026
Your Price
$19.48
  Special Order
Kelvinator Dishwasher Tower Star Gasket
PartSelect Number PS447095
Manufacturer Part Number 3205549

Related Kelvinator Dishwasher Parts