The Fuel Tank Grommet is a 1-inch, black, rubber part. It attaches to the fuel tank so you can run your fuel lines through it, and is rated as "Easy" to install by most of our customers. If worn or damaged, it will begin to leak fuel, and must be replaced. Refer to your make, model and diagrams to ensure you're choosing the right part.

The fuel filter clamp, is a silver, individually sold, metal part, used to secure the fuel line to the fuel filter. It attaches to the fuel filter and if broken, typically due to fatigue or damage, it should replaced. Installation is rated as "Easy" and requires Pliers and a Screwdriver. When removing the fuel line to remove the old clamp, make sure you have a bucket to catch the fuel. Refer to your make, model, and diagram to ensure you're choosing the right part.

The Primer, or priming pump, is a plastic part that attaches to the carburetor. It's rated as "Easy" to install by most of our customers. This part is used to pump fuel from the fuel tank to the carburetor or to start the engine. If damaged, it will no longer pump fuel. It may also be physically, noticably broken. Replace this part if damaged. Check your make, model and diagrams to ensure you're choosing the right part.

The Fuel Cap Assembly, is a black, plastic cap that keeps fuel inside the tank, and debris out. If broken, fuel will begin leaking out and it must be replaced. Installation is rated as "Easy", the part simply attaches on top of the fuel tank. Refer to your make, model, and diagram to ensure this is the correct part.