Official Jenn-Air Ice Maker Parts

Ice Maker Bin Temperature Sensor – Part Number: WPW10511923

40% OFF

Your Price

$43.89

$73.57

Jenn-Air Ice Maker Bin Temperature Sensor

★★★★★

18 Reviews

PartSelect Number PS11755842

Manufacturer Part Number WPW10511923

This bin temperature sensor is for ice makers. The bin temperature sensor monitors the temperature in the ice maker bin and sends the temperature reading to the electronic control board. Disconnect the power before installing this part. Wear work gloves to protect your hands.

Installation Instructions

Travis from N CHESTERFLD, VA

Ice bin overfilling

I'm an hvac/r technician, and regularly work on ice machines. Begin my pulling the white over beneath the control panel. It snaps in place so pull on the bottom then left out. 1/4 nut driver is all you need, and remove the screw holding the bin thermistor clip to the side. Up to the right , beneath the control panel, behind the plastic panel you previously removed is the mollex connector. Unplug the thermistor and follow instructions in reverse to reinstall. Read more...

Refrigerator Water Filter – Part Number: F2WC9I1

Your Price

$75.32

Jenn-Air Ice Maker Refrigerator Water Filter

★★★★★

8 Reviews

PartSelect Number PS8759230

Manufacturer Part Number F2WC9I1

This genuine OEM replacement part is a water filter for your fridge or freestanding ice maker. The filter is used to remove contaminants and particles from the water, to ensure a clean and fresh taste. The filter should be replaced every six to nine months, or after 2000 gallons of water have passed through, whichever occurs first.

Videos!

Condenser Fan Motor Kit – Part Number: W10124096

Your Price

$127.42

Jenn-Air Ice Maker Condenser Fan Motor Kit

★★★★★

51 Reviews

PartSelect Number PS1957416

Manufacturer Part Number W10124096

This condenser fan motor kit includes a motor, fan blade, wire harness, and screws. Used in a refrigerator, the condenser fan motor moves the condenser fan blade to direct and move air across the condenser coil. Please note: The manufacturer has changed the appearance of the product from the original. The kit still functions the same as the original part. It is an OEM factory replacement. Make sure to unplug the refrigerator from the power source and wear gloves to protect your hands. Also, a helpful tip is to store food to prevent deterioration when the power is off.

Fixes these symptoms

Clicking sound
Freezer section too warm
Fridge and Freezer are too warm
See more...

Installation Instructions

Josue from Jacksonville, NC

Seven year old condenser fan was making noise when it was running.

The process to repair was very simple, I removed the back of the refrigerator to expose the motor area. I then removed three screws that held the condenser motor in place. once it was loose I detactched the electrical harness and removed the old motor. I then placed the new motor in place and secured it with the screws and reattached the new electrical harness that came with the new part. Once completed I reviewed it to make sure I didn't miss anything. I then replaced the cover over the motor area and enjoyed my success in repairing my own appliance with no added cost for labor, which would have been expensive I'm sure. The part purchased came with clear and consice instructions very easy to follow. Read more...

Water Inlet Valve – Part Number: W10897719

Your Price

$144.48

Jenn-Air Ice Maker Water Inlet Valve

★★★★★

1 Review

PartSelect Number PS11765823

Manufacturer Part Number W10897719

This water inlet valve supplies water to the ice maker, allowing it to fill the reservoir and produce ice. If your ice maker is not filling correctly or is experiencing water flow issues, replacing this valve may resolve the problem. Always disconnect power and water supply before installation and verify compatibility with your model.

Your Price

$67.59

Jenn-Air Ice Maker Pump

★★★★★

8 Reviews

PartSelect Number PS16730541

Manufacturer Part Number W11566405

A recirculating pump is used with standalone ice cube makers. It circulates the water over the top of the evaporator plate, which produces a layer of ice that is then broken down into ice cubes. If you notice that your ice maker is no longer producing ice or there is no water flowing over the cooling plate, this could be due to the recirculating pump not working. Be sure to keep the pump clean and free of build-up. This pump is 5.75 inches in length, 4.75 inches in width, 4.25 inches in height and weighs 0.81 lbs. This is a genuine OEM appliance part that comes directly from the manufacturer.

Installation Instructions

Richard from North Wilkesboro, NC

was not making ice

diagnosed no water flow over evaporator checked voltage into pump then checked pump with ohm meter ordered pump and installed by removing access cover and water holding assembly installed new pump replaced water holding assembly and access cover and returned icemaker to service all is well Read more...

CIRCULATION PUMP – Part Number: W11542868

Your Price

$65.48

Jenn-Air Ice Maker Circulation Pump

★★★★★

2 Reviews

PartSelect Number PS16555298

Manufacturer Part Number W11542868

Installation Instructions

Jonathan from WILLIAMSBURG, VA

Water not refilling after initial batch of ice

The water filled on startup (actually over-filled, which was a clue). After that water was used to make ice, no new water came in so the recirculation pump just made whining noises in the mostly empty reservoir. Since water could come in (on start up) I reasoned it wasn't the water inlet valve, and everything else suggested the ice maker was getting inaccurate info about how much water was in the reservoir. Turns out, the water recirculation pump has a water level sensor built in. So while the pump itself still functioned, the water level sensor inside had gone bad. Replacing the pump fixed the issue. There are videos online that show how to accomplish that, but it was pretty straight-forward. The dis-assembly was sometimes irritating because it's hard to see and maneuver around inside. It'll help if you put the machine closer to eye level. Pay close attention to videos that show the disassembly because there are a couple of tabs that are hard to find. Read more...

Videos!

Your Price

$28.64

Jenn-Air Ice Maker Switch

★★★★★

15 Reviews

PartSelect Number PS12584655

Manufacturer Part Number W11291138

This is a light switch for your refrigerator. It activates when the door of your appliance is opened, and it will turn the light inside on and off. You will need to replace this part is if your light is not working properly. In order to make this repair you will need a Phillips screwdriver, a pair of needle nose pliers, and a small flat blade screwdriver. This light switch is almost 2 inches long, 1.5 inches wide, and just over an inch thick.

Fixes these symptoms

Light not working
See more...

Installation Instructions

Fred from Oceanport, NJ

Door switch module wore out

Pull out old module...
Remove 2 wires...
Tape to inside wall [don't want them to fall down into side panel]..

Order new switch..

Fed Ex pkg came on 2nd day..

Install wires on switch...
Press into opening...
Check door light on..[OK]
.. Done Read more...

Ice Cutter Grid Complete Assembly – Part Number: WP2313637

Your Price

$185.26

Jenn-Air Ice Maker Ice Cutter Grid Complete Assembly

★★★★★

14 Reviews

PartSelect Number PS11740334

Manufacturer Part Number WP2313637

If your freestanding ice maker is not producing ice properly, the ice cutter grid assembly may need replacing. The cutter grid is located within the main unit of the ice maker and contains thin, heated wires that slice the ice into cubes that are then deposited in the ice bin. If the cutter grid is broken, ice can back up within the ice maker. This part is sold as a complete assembly and is used with freestanding ice makers. Be sure to wear work gloves to protect your hands when completing this repair. This is an OEM part that sources directly from the manufacturer.

Installation Instructions

Brad from Bakersfield, CA

Grid Assembly had a broken wire and would not separate the ice sheets into cubes

I removed the 2 screws on each side of the grid and disconnected the electrical plugs attached to the grid. I slid the broken unit out. I then carefully slid the new unit in making sure not to pinch any of the electrical wires. I replaced the mounting screws, plugged the 3 connectors back into place and turned the ice maker back on. I had ice cubes within a couple of hours Read more...

Water Inlet Valve with Quick Connections - 120V 60Hz – Part Number: W10881366

Your Price

$117.32

Jenn-Air Ice Maker Water Inlet Valve With Quick Connections - 120v 60hz

★★★★★

5 Reviews

PartSelect Number PS11738179

Manufacturer Part Number W10881366

Used with freestanding ice cube makers.

Installation Instructions

william from etowah, TN

Ice maker started leaking water from the water valve that inputs water to the appliance.

removed the front cover below the compartment door,removed the 2 screws holding the valve to the case and removed the water lines from the valve.The process was reversed to install the new valve. Read more...