Jenn-Air Dishwasher Pumps | Replacement Parts & Accessories | PartSelect

Popular Jenn-Air Dishwasher Pumps

Your Price
$26.38
Chopper Assembly
PartSelect Number PS11722146
Manufacturer Part Number W10083957V
This is a chopper assembly or drain food chopper, and it is designed for your dishwasher. The chopper chops up/minces the food particles in your dishwasher to prevent them from clogging the pump. You may need to replace this part if your dishes are not being cleaned properly, your appliance is particularly noisy, or you are noticing draining problems. The tools you will need to make this repair include a number 20 and a number 15 torque screwdriver, a small flat blade screwdriver, and a pair of needle nose pliers.
Fixes these symptoms
Noisy
Not cleaning dishes properly
Not draining

See more...
Installation Instructions
Bill from North Richland Hills, TX says,

Dishes on top rack of dishwasher were not being cleaned.
1) Remove top and bottom dish baskets from the dishwasher, this will give you room to work. To remove top basket there are clips at the end of the slide rails.
2) Remove lower spray arm by unscre...read more

Your Price
$68.21
Drain Pump - 120V 60Hz
PartSelect Number PS11753379
Manufacturer Part Number WPW10348269
This drain pump is used in dishwashers to remove water from the dishwasher tub. If the impeller in the dishwasher is damaged or the motor has been shorted out and will not drain, it is possible the body is cracked, causing leakage. To prevent this from happening, replace the drain pump. The tools needed for this installation are: Phillips screwdriver, 5/16 inch nut driver, 5/8 inch wrench, and a flathead screwdriver. Remember to unplug your dishwasher from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for further installation instructions.
Fixes these symptoms
Leaking
Noisy
Not cleaning dishes properly

See more...
Installation Instructions
Andrew from Alexandria, VA says,

dishwasher not draining after wash cycle
Caviat: The actual repair is less than 15 minutes, but I spent a lot of time playing with it before I figured out it was that easy and fast. You don't need to remove the dishwasher from the counter to...read more

Your Price
$206.43
MOTOR-PUMP
PartSelect Number PS11773089
Manufacturer Part Number W11032770
Fixes these symptoms
Not cleaning dishes properly


Installation Instructions
christopher from MOSES LAKE, WA says,

wash pump stopped working
change out the old pump with new one actually quieter running pump awesome...read more

Your Price
$96.27
Sump
PartSelect Number PS11755006
Manufacturer Part Number WPW10455268
This works in conjunction with the pump and filtration system. It is used to receive drainage for disposal.
Fixes these symptoms
Leaking


Your Price
$72.26
PUMP-DRAIN
PartSelect Number PS11738151
Manufacturer Part Number W10876537
Fixes these symptoms
Not draining


Installation Instructions
Kelli from BURLINGTON, MA says,

Dish washer would not drain properly
Shut off breaker. Took off front skirt of dishwasher .
Used pliers to loosen the pressure clamp on drain pump , have towel handy as there will be some water. Turn pump to left as you push in o...read more

Your Price
$52.49
Drain Pump
PartSelect Number PS11756031
Manufacturer Part Number WPW10531320
Fixes these symptoms
Leaking
Noisy
Not draining

See more...
Installation Instructions
Paul from CANONSBURG, PA says,

Drain pump flange broke
Laid on my side amd reach under unit...read more

Your Price
$60.79
Impeller and Seal Kit.
PartSelect Number PS12069388
Manufacturer Part Number 8193951A
This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
Leaking
Noisy
Not cleaning dishes properly

See more...
Installation Instructions
Chauncey from Menan, ID says,

Started with a grinding noise in the bottom of the dishwasher, and then the thing just stopped cleaning the dishes. It wasn't pumping any water,
I removed the plasic inner parts, used the torx drivers to remove the internal platic plate that covered the sump. Found the food chopper cover and removed it. It had gotten a piece of plastiic wra...read more

Your Price
$26.05
Wash Impeller
PartSelect Number PS11747701
Manufacturer Part Number WP99002659
This impeller rotates and is used to force water up through to the spray arm.
Fixes these symptoms
Leaking
Noisy
Not cleaning dishes properly

See more...
Installation Instructions
Timothy from Trevor, WI says,

Dishwasher would fill properly but when wash cycle would start you could not hear any water spraying.
First I removed the lower spray arm by removing the middle retainer nut. Next remove the 3 screws holding the outer shroud in place. Next remove 6 screws holding the water pump top housing in place. U...read more

Your Price
$75.21
Accumulator and Filter
PartSelect Number PS897295
Manufacturer Part Number 8193918
This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.
Fixes these symptoms
Not cleaning dishes properly


Your Price
$21.26
Impeller Assembly
PartSelect Number PS11747641
Manufacturer Part Number WP99002069
This impeller rotates and is used to force water up through to the spray arm.
Fixes these symptoms
Noisy
Not cleaning dishes properly
Not draining

See more...
Installation Instructions
William from Pottstown, PA says,

poor design causes filters to clog easily
removed lower spray arm and the 6 torx screws that hold the pump cover and secondary filter housing. Removed it and the filter. Removed the pump housing and removed the impeller nut with a 5/16 nut...read more