Jenn-Air Appliance Parts

Jenn-Air Appliance Parts
Shop By Appliance Type

Popular Jenn-Air Appliance Parts

Your Price 5.96
  In Stock
Light Bulb - 40W
★★★★★
★★★★★
(52)
PartSelect Number PS884734
Manufacturer Part Number 8009
This an authentic OEM 40-Watt replacement light bulb, used in a number of household appliances. It is specially designed to withstand extreme temperatures, which is why these replacement bulbs are most often used to light the inside of refrigerators and ranges. It features a standard socket base, which means you simply unscrew the burnt-out bulb and screw in the replacement. Depending on the appliance you may require a screwdriver or nut driver to access the light bulb. We recommend you wear work gloves while handling this replacement part.
Installation Instructions
judie from mays landing, NJ
interior drawers were off their rollers
pulled the washer out and replaces the top roller system on both sides and the replaced the weels and brackets on the bottom drwaer. however i had trouble putting the dish washer back correctly and had to call a repairman to adjust the dishwasher and alighn it to open and close properly. but i did do good inside. i feel it was easy and a success. thank you for having the supplies for us to attempt to repair it on our own. Read more...
Your Price 68.35
  In Stock
Refrigerator Water Filter
★★★★★
★★★★★
(55)
PartSelect Number PS11722128
Manufacturer Part Number EDR3RXD1
This NSF Certified water filter reduces 66 contaminants, which include pharmaceuticals, pesticides, lead, asbestos, industrial chemicals, and more. It measures 2.6 inches deep, 13.5 inches high, and 3 inches wide. By limiting the presence of chlorine in the water, it provides healthy and better tasting water. This filter is for side-by-side refrigerators and is found behind the front, bottom panel of the appliance. For this installation, first disengage the old dispenser while using a cloth to catch any dripping water. Attach the bottom cap to the new one and slip into place. It will click once it is secured. Run water for a few minutes to prime the filter before using. For best results replace every six months.
Fixes these symptoms
  • Ice maker dispenses too little ice
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • See more...
Installation Instructions
Kate from Jacksonville, FL
there were directions
We didn't know where the product went and it was very difficult to install. Read more...
Your Price 68.35
  In Stock
Water Filter
★★★★★
★★★★★
(51)
PartSelect Number PS11722130
Manufacturer Part Number EDR4RXD1
This OEM filter is sold individually. It is used in bottom-freezer and side-by-side refrigerators that accept Filter 4. It is white in color, and measures 8 inches by 3 inches in diameter. By removing impurities and pollutants, you will ensure better tasting and clear drinking water. Locate your filter holder on the inside of the refrigerator. Release the old one and position the new one into the housing. Click it into place so that you know it is locked and secured. Be careful not to damage the filter by over-tightening. Finally, run water through the dispenser so it is ready for use. Refer to the Water Filtration System section in your user guide for more detailed instructions. It is recommended that you change out your filter every six months.
Fixes these symptoms
  • Fridge too cold
  • Ice maker dispenses too little ice
  • Ice maker not making ice
  • See more...
Installation Instructions
Douglas from Byron, NY
light on to order water filter
Pressed in the end of the filter cover, lowered it down part way. Twisted the old filter 1/4 turn and removed it. Set in the sink to drain. Inserted new filter and twisted it to lock. closed cover. Done. Total time @ 1 Minute. Read more...
Your Price 109.98
  In Stock
Replacement Ice Maker
★★★★★
★★★★★
(105)
PartSelect Number PS2121513
Manufacturer Part Number D7824706Q
This is a replacement ice maker. This assembly includes the ice mold and the control device. The water inlet valve pumps water into the mold, which stays there until it is frozen solid and ejected into the storage bucket. The process continues until the bucket is full. This replacement part does not include the cover, shut off arm, wire harness, or the mounting hardware. You will need to use the existing pieces, or order those separately. You will need a nut driver to successfully install this part. Unplug your appliance before you begin any repair work.
Fixes these symptoms
  • Ice maker dispenses too little ice
  • Ice maker dispenses too much ice
  • Ice maker not making ice
  • See more...
Installation Instructions
Bernie from Diamond Bar, CA
Icemaker producing few or no cubes and often leaving "kling-ons" on ice tray
Interior surface of ice tray felt rough & flaky (coating deteriorated) so cubes would not release.
Unplug appliance.
Remove timer cover by hand pressure @ edge.
Remove single attachment screw & bracket at lower front of icemaker.
Disconnect wiring harness from socket @ rear of compartment.
Tricky part was determining what type of connection held the other two attachment points along the long edge of the icemaker. I did not have repair manual or useful drawing but looked @ PartsDirect pic of side brackets & used a small mirror to confirm that mine were also some sort of "snap in" attachment.
Remove icemaker unit by pushing upward and outward on the unit. I takes a good bit of pressure and will pop loose, but be careful not to break attachment bracket from freezer wall.
Scavenge shut off bar and wiring harness from old icemaker once you have it out & attach to new one before installing it back in freezer.
Again, you might find a mirror useful to align those pesky snap-in brackets with the new unit.
Since you probably kept your freezer running while waiting for the part, the plastic snap-ins will be cold and brittle. I warmed them up first by applying a dampened cloth heated in the microwave to make them a little more pliable.
A good push of the new unit towards the snap-ins along with some upward force will get it stable.
Reattach the metal screw in bracket & connect the wiring harness to rear plug... and don't forget to plug the whole thing back in.
It will take awhile for the first batch of cubes dump as the timer may need to cycle completely around to get to the fill cycle... be patient.
Dump the first couple of batches of cubes just to make sure you're free of any residue.
Read more...
Your Price 17.07
  In Stock
Refrigerator Door Switch
★★★★★
★★★★★
(53)
PartSelect Number PS12728638
Manufacturer Part Number W11384469
Door switch turns the light off when you close the door.
Fixes these symptoms
Installation Instructions
Clint from Rayville, MO
Lights inside refrigerator not working
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. Read more...
Your Price 29.72
  In Stock
Dishwasher Lower Dishrack Wheel Assembly - Gray
★★★★★
★★★★★
(207)
PartSelect Number PS11722152
Manufacturer Part Number W10195416V
The lower dishrack wheel is used in a dishwasher to easily roll the dishrack back and forth on the rails. To repair, open the dishwasher door and pull out the lower dishrack. Next, push the tab from both sides and it should pop out. To install the new wheel assembly, place it on the rack and make sure the caps overlap the wire from the inside before you clip it in place by pushing the wheel. Slide the rack back in the dishwasher to make sure it is installed correctly. Refer to the manual provided by the manufacturer for further instructions.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...
Installation Instructions
Thomas from WEST OLIVE, MI
Broken wheel unit on the bottom dish rack
All you do is pop out the old wheel unit at two (2) points on the plastic wheel housing and pop in the new one. Easy fix. Less than a 5 minute fix. Read more...
Your Price 50.65
  In Stock
Capacitor
★★★★★
★★★★★
(27)
PartSelect Number PS11757023
Manufacturer Part Number WPW10662129
This capacitor is also known as a run capacitor, and it is most often used in refrigerators and freezers. This part provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. Doing so enables the appliance to effortlessly maintain its internal temperature. If the capacitor is faulty your refrigerator or freezer might be too warm, or you may notice the compressor will hum, but it will not run. When replacing your capacitor, you should check the old one for any signs of damage, overheating, or arcing, as that may suggest there is a bigger problem with your appliance.
Fixes these symptoms
  • Clicking sound
  • Freezer section too warm
  • Fridge and Freezer are too warm
  • See more...
Installation Instructions
garth from forest lake, MN
My refrigerator stopped cooling and the freezer section stopped freezing
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot so I did give it a shot. I ordered the parts and they were there in less time than a service tech could come out and i installed the parts and guess what for 90.00 in parts and 15 minutes in time I repaired my refrigerator. Thanks guys, It took less time to order the parts than it did to make the repair so thanks, your website rocks and is very well designed so my hat is off to you guys! Read more...
Your Price 4.73
  In Stock
Light Bulb - 40W
★★★★★
★★★★★
(117)
PartSelect Number PS2376034
Manufacturer Part Number 8206232A
This exterior light bulb for your microwave is 40W and has a small screw-in base. To access the exterior light bulb, you will need to remove the panel on the bottom of the microwave using a Phillips screwdriver. If your exterior light bulb has not been changed before, it is probably held in place with some silicone. You will need to cut away this silicone to remove the old bulb. If you cannot access the silicone with a utility knife, it can be removed using dental floss. Once the silicone is removed, simply unscrew the old bulb, and replace it with the new one. Be sure to disconnect the power to the microwave before you begin this repair.
Installation Instructions
Chris from Cedar Hill, TX
Burned out light under microwave and Filters needed changing
I just removed the multiple screws which held the hood cover on. I then attempted to remove the light bulbs from the socket. This proved impossible because the bulbs were so fragile from the heat and grease build up. To make this task much easier and probably safer, just replace the bulb housing and light bulb. The bulb housing unplugs very easily. Just replace it then screw your new bulb in. P.S. Be sure to unplug appliance before you start.

The filters are very easy to replace. No tools needed.

Hope this helps.
Read more...
Your Price 14.38
  In Stock
Silverware Basket - Gray
★★★★★
★★★★★
(67)
PartSelect Number PS11743069
Manufacturer Part Number WP6-918873
This silverware basket is gray in color and measures 8 inches wide by 11-1/2 inches high by 12 inches deep. The silverware basket is used to hold small utensils such as forks, spoons, and knives during dishwashing. The manufacturer has redesigned this part to be a complete, full basket with a handle and covers. The basket comes apart in two pieces if you prefer to place them along the sides of your dishwasher instead of at the front section of your bottom dish rack. To prolong the life of this part, try to place utensils into the holders carefully instead of dropping them in.
Fixes these symptoms
Installation Instructions
Cheryl from South Burlington, VT
bottom rack needed replacing
Just took it out of the box and slid it in.
Only problem I encountered, and I think it was due to the age of the dishwasher, was the newunit was not as deep as teh original rack. This will require a new method of loading dishes. Also, the new basket doesn't really fit well in the new rack.
Still cheaper than replacing a good cleaning dishwasher!
Read more...
Your Price 17.07
  In Stock
Refrigerator Door Switch
★★★★★
★★★★★
(18)
PartSelect Number PS12731166
Manufacturer Part Number W11396033
This light switch may also be known as a refrigerator door switch or a light switch kit, and is compatible with your refrigerator. The function of the refrigerator door switch is to turn on the light when your fridge door is open, and to make sure it is off when your refrigerator door is closed. The reason you would need to replace this part is if your light is not turning on when your door is open. For this repair, you will need a putty knife, and a small flat-blade screwdriver.
Fixes these symptoms
  • Ice maker not making ice
  • Light not working
  • Not dispensing water
  • See more...
Installation Instructions
Kevin from Beckley, WV
while closing the door, the light switch fouled, resulting in the switch breaking
I used a flat screwdriver and released the lock tab on the bottom of the light switch, and pried the switch out, being careful to not damage the plastic around the mounting place of the switch, unplugged wiring from old switch, plugged in the new one and pushed the new switch into place. Job finished light switch now working. Read more...

Appliance Type

Popular Jenn-Air Appliance Models

Below are the most popular Jenn-Air Appliance models we have. Enter your model number in the search box to find your model.