Gibson Oven Parts

Popular Gibson Oven Parts

Your Price
$10.89
   In Stock
Gibson Oven LENS
★★★★★
★★★★★
7 Reviews
PartSelect Number PS16218465
Manufacturer Part Number 5304524341
The Frigidaire light bulb lens covers the interior light bulb in an oven. No tools are necessary to replace this item. After unplugging the appliance, slide off the wire bracket to remove the existing light bulb lens. Be sure to remove all broken glass, if applicable, before installing the new lens. It is recommended to check the state of the light bulb while the lens is off. This part is made of glass. The lens is a genuine Frigidaire part, sourced directly from the manufacturer, and is sold individually.
Installation Instructions
Jim from Harrison, MI
Lower baking element would not heat up.
Your online instructions said to remove the two screws and pull out the heating element about 3 inches and disconnect. When I did this the element came out but not where it was connect to the wire., I could not locate the wire from the front of the oven. I then pulled out the oven from the built in cabinet and removed the rear panel. Then inserted the element with the 2 screws from the front and connect the wires to the element from the back of the oven. Jim Read more...
Your Price
$9.38
   In Stock
Gibson Oven Main Terminal Block Kit
★★★★★
★★★★★
12 Reviews
PartSelect Number PS471605
Manufacturer Part Number 5304409888
Terminal block kits are also known as terminal boards, or terminal strips, and they are found in a wide variety of household appliances. Most often in ranges, wall ovens, and dryers. This kit attaches the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to operate properly. When removing the old block pay close attention to the wire placement, this will make installing your new part much easier. If you notice any of the wires or wire terminals are corroded or damaged they will also need to be replaced.
Fixes these symptoms
  • Element will not heat
  • Little to no heat when baking
  • Little to no heat when broiling
  • See more...
Installation Instructions
Timothy from Spring Valley, AL
Cord was not tightened enough by delivery crew.
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screwdriver, deep socket for lug nuts. Nut driver optional. Hope this is helpful. Read more...
Your Price
$148.21
   In Stock
Gibson Oven Bake Element
★★★★★
★★★★★
6 Reviews
PartSelect Number PS978772
Manufacturer Part Number 318255101
This is a 2100 watt bake element for your oven or range. The element supplies heat from the bottom of the oven to bake or cook your food. You may need to replace the bake element if your oven is not heating properly. Simply remove oven racks to access the bake element. Use a Phillips screwdriver to remove the two screws that secure the element to the oven body. Electrical wires feature slip-on connectors for easy installation, but be sure to hold the wires forward so the wires do not fall back through the rear of the oven. Unplug your appliance or shut off your circuit breaker to the appliance before installing the new part.
Fixes these symptoms
  • Element will not heat
  • Little to no heat when baking
  • See more...
Installation Instructions
James from Delaware, OH
Element showed a hot spot prior to failing open.
Replaced element. Removed shelves, removed two screws and lifted/wiggles old element out to pull wires off at connectors. Reversed process installing new element and truned on to test/burn off "newness" Done! Read more...
Your Price
$46.54
   In Stock
Gibson Oven Light Socket
★★★★★
★★★★★
4 Reviews
PartSelect Number PS439060
Manufacturer Part Number 316116400
The oven light socket allows you to screw in a light bulb so that you can see the inside of your oven. The light socket is located in the back of your oven, so you will need to remove the back panel to access the socket for the repair. You will also need to remove the current light bulb and the light lens cover so that the old socket can be removed. As you will be working around electrical circuits for this repair, be sure to disconnect the power source from the oven before you begin work on the oven.
Fixes these symptoms
Installation Instructions
Paul from Spokane Valley, WA
Oven light receptacle broken - bulb base broke off
Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snapped in easily from inside the oven as well. Replaced wiring, installed new bulb, restored power & tested. Replaced back cover. Good time to vacuum under/behind where the oven usually lives before sliding it back to the wall. Read more...
Your Price
$42.74
   In Stock
Gibson Oven Door Switch
★★★★★
★★★★★
3 Reviews
PartSelect Number PS3633434
Manufacturer Part Number 318394803
The door lock switch, or simply door switch, is used in ranges and ovens. The switch activates signals to the oven control board about the state of the door lock. If the light in the oven is not turning on or off, or the self-cleaning option is not working, it is best to replace the switch to solve your issues. The tools needed for this installation project are a flat-head screwdriver, Phillips-head screwdriver, and pliers. To repair, first remove the screws from upper rear access panel, then open oven door to disconnect the door switch wire connecter. Next, remove switch assembly through the access hole and unhook the old hook from the actuator rod. Now you can install the new switch by hooking it on to the rod and back into place. Refer to the manual provided by the manufacturer for further installation instructions and guidance.
Installation Instructions
Gregory from Croton-on-Hudson, NY
Oven Door Light Switches Wrecked by Heat from Oven
Pull old switches out with pliers and replugged new switches. On main oven, plug casing was melted (wife left broiler on with oven door closed) so had to break apart old casing and individually plug the the wires into new switch and amazingly, it worked! Just gotta keep the door open when broiling............. Read more...
Your Price
$68.18
   In Stock
Gibson Oven Broiler Pan Grate Insert
★★★★★
★★★★★
3 Reviews
PartSelect Number PS9864838
Manufacturer Part Number 5304494997
This OEM broiler pan and grate insert are cooking accessories used in your oven to broil food. The pan catches drippings and prevents them from falling into the appliance, while the grate insert ensures the food is cooked evenly. You can usually find them at the bottom of your appliance. If your broiler pan and grate insert are broken, your food may not cook evenly and the drippings may fall into your appliance. Additionally, it can be difficult to clean a damaged pan or grate. These authentic accessories come together when you purchase them, ensuring that you can enjoy evenly-cooked food without any mess.
Your Price
$76.78
   Special Order
Gibson Oven Rack
★★★★★
★★★★★
3 Reviews
PartSelect Number PS2368962
Manufacturer Part Number 318345216
This oven rack is a genuine OEM part that measures approximately 18 1/4 by 15 inches. It acts as a shelf for placing food while it cooks or bakes in your oven. You will find it inside the oven cavity, and you can adjust its height to different positions. If the rack is damaged, you might notice bent metal bars, broken welds, or loose connections. It can also get stuck when you try to slide it in or out of the oven. If you do not replace a broken oven rack, your food may cook unevenly, and there is a risk that the rack might unexpectedly collapse, causing spills or burns. To remove an oven rack, first make sure your oven is turned off and cooled down. Open the oven door and grip the rack with both hands. Lift the front end slightly and tilt it upward while pulling it toward you until it slides out completely. If it is stuck, you can try gently moving it back and forth or side to side. Using food-safe lubricants can also help in this situation. If you are replacing more than one rack, please keep in mind that this part is sold individually.
Your Price
$170.17
   In Stock
Gibson Oven Broil Element
PartSelect Number PS453603
Manufacturer Part Number 5303016247
This broil element supplies heat for cooking and is located in the roof of an oven. If there is little to no heat when cooking, a damaged element, or food is taking too long to cook, these symptoms could be solved by replacing this part. Before starting this replacement, make sure to unplug your range from the power source or shut off from the house circuit breaker. You will need a Phillips screwdriver to complete this repair. This part comes in a matte black color. For safety reasons, make sure to wear gloves. Refer to the manual provided by the manufacturer.
Fixes these symptoms
Installation Instructions
Cherilyn from W HOLLYWOOD, CA
No instructions needed
Just slide the rack into the oven! Read more...

Gibson Oven Appliance Types

Popular Gibson Oven Models

Below are the most popular Gibson Oven models we have. Enter your model number in the search box to find your model.