General Electric Washer Hinges

Videos!

Your Price

$13.91

General Electric Washer Door Hinge

★★★★★

1 Review

PartSelect Number PS8756812

Manufacturer Part Number WE1M1033

Screws NOT included.

Fixes these symptoms

Door won’t close
See more...

Your Price

$13.91

General Electric Washer Hinge Lid Scr 6-32 Mch F

PartSelect Number PS12171501

Manufacturer Part Number WH02X24634

Videos!

Your Price

$27.87

General Electric Washer Hinge Bushing

★★★★★

1 Review

PartSelect Number PS268416

Manufacturer Part Number WH01X10025

Installation Instructions

Thomas from Baltimore, MD

knob asm control/ bushing hing

First remove clip with srewdriver and pulled the knob off, then replace with new knob and replaced the clip, the next thing I removed two screws with a philps screwdriver and remove the the bracket then I slip the bushing on the bracket took a little while to figure how to replace it in the process of replacing the two screws I broke the bracket which I will order later, the only real problem I had was I did not have to order the timer knob clip because it came with the knob the picture did not imform me that it was there other then that it was easy Read more...

Your Price

$13.91

General Electric Washer Hinge Bushing

★★★★★

1 Review

PartSelect Number PS271111

Manufacturer Part Number WH1X2741

Installation Instructions

Michael from Ballwin, MO

unit would not agitate or spin

I checked the motor,it was bad I was pulling to 20 amps too much. The washer was still not working and the motor was bad so I checked the lid switch for continuity. The switch was a magnet type so with the lid down you should have continuity. In other words, a closed circuit. When the lid is opened, you should have a open circuit, Which would show no continuity. An open circuit means a break in the circuit. To change hinge bushings, raise lid, remove the screws on the outside of the lid, remove hinge, remove lid, insert new hinge bushings, place hinge through lid into bushings, and then put the screws back into the lid. If you followed these steps you should be done. Read more...