General Electric Microwave Caps and Lids
Find your partEnter your model number or a part number and click "Search"
Here is an example model number plate:
Popular General Electric Microwave Caps and Lids
Stirrer Fan Cover
PartSelect Number PS1480811
Manufacturer Part Number WB06X10712The stirrer fan cover in your microwave can be found on the roof of the microwave. It protects the fan from damage and debris. This fan cover is made of white plastic and is approximately 7.5 inches in diameter. Occasionally, the stirrer fan cover can melt, and become damaged. If you smell burning from your microwave or notice damage, the fan cover should be replaced. The stirrer fan cover is sold individually, and is an OEM part directly from the manufacturer.
Steven from UTICA, NY
cover stirrer fan was burned and sparking in three part even the plastic rivetjust in 1 2 3 step easy way. First unplug the power cord,use a small flat-head screwdriver to pull out the plastic rivet pin,rotate the old cover counter clockwise to removed lift out the blade assembly, install the new cover stirrer fan by first positioning the blade assembly then align the cover and rotate it clockwise to secure, then replace the mounting plastic rivet pin;with the repair completed, plug the power cord back in and your microwave oven should be ready for use again. : ) Read more...
Wave Guide Cover
PartSelect Number PS228021
Manufacturer Part Number WB06X10311
Grafals from Collingswood, NJ
The wave guide cover gets caught on fire when using microwave.First removed the screw that holds the cover. Replace it and put the screw back on. Se acabó. So easy. I will go easy using harsh detergents that may had damage the cover. Read more...
Wave Guide Cover
PartSelect Number PS1020520
Manufacturer Part Number WB48X10047This is the replacement wave guide cover for your microwave. It is white in color and is approximately 3 ½ inches long and 4 inches wide. It has two small tabs at the top that allow it to lock into place. The wave guide cover transmits microwave radiation while preventing steam and food particles from interacting with the sensitive electronic components of the microwave. If your wave guide cover is damaged or missing, it will need to be replaced. Be sure to disconnect power from the microwave before you begin this repair. This part is sold individually and is an OEM part.
Wave Guide Resin Cover
PartSelect Number PS2321139
Manufacturer Part Number WB06X10764
PartSelect Number PS1017735
Manufacturer Part Number WB06X10638
Bill from MAGNOLIA, TX
The part was burnt and was causing sparking inside the microwaveRemoved the old canopy mica, it has tabs that slip into slots on the top of the microwave. Then installed the new part, the tabs are inserted into the same slots. Read more...
PartSelect Number PS2369910
Manufacturer Part Number WB06X10828
Light Cover Frame
PartSelect Number PS651487
Manufacturer Part Number WB36X10216Glass not included.
jerene from Houston, TX
Glass was brokenI took the cover off, and replaced the glass-- the difficult part, was ordering the glass..on the list of parts to order-- the description of the glass was mis-leading Read more...
PartSelect Number PS227845
Manufacturer Part Number WB06X10130
john from LAGUNA NIGUEL, CA
Had a fire in M/W, melting the film and also the spinner coverRemoved old film, installed new horizontally and pulled it downward (match it along the top first). The cover required 2 "hooks" to be removed, only needed 4 clips. Used a screwdriver to remove the 2 clips. Read more...
WAVE GUIDE COVER WITH NU
PartSelect Number PS9493024
Manufacturer Part Number WB34X21610