Frigidaire Range Lights and Bulbs

Your Price

$33.34

In Stock

Light Bulb Lens

★★★★★

(4)

PartSelect Number PS2349721

Manufacturer Part Number 318406100

The Frigidaire light bulb lens covers the interior light bulb in an oven. No tools are necessary to replace this item. After unplugging the appliance, slide off the wire bracket to remove the existing light bulb lens. Be sure to remove all broken glass, if applicable, before installing the new lens. It is recommended to check the state of the light bulb while the lens is off. This part is made of glass. The lens is a genuine Frigidaire part, sourced directly from the manufacturer, and is sold individually.

Installation Instructions

Jim from Harrison, MI

Lower baking element would not heat up.

Your online instructions said to remove the two screws and pull out the heating element about 3 inches and disconnect. When I did this the element came out but not where it was connect to the wire., I could not locate the wire from the front of the oven. I then pulled out the oven from the built in cabinet and removed the rear panel. Then inserted the element with the 2 screws from the front and connect the wires to the element from the back of the oven. Jim Read more...

Your Price

$11.14

On Order

Light Lens Indicator

★★★★★

(1)

PartSelect Number PS2342816

Manufacturer Part Number 316557300

Installation Instructions

Kathy from NEW BERN, NC

Burner indicator light lense broke off

The light apparatus was loose behind the panel. Remove the remaining part of the lens. Install the new lens from the outside of the panel and hold it in position, protruding into the inside of the panel. Slide the light apparatus onto the lens from the inside, allowing the bracket to hold it in place - it will be spring loaded, which will hold it in place. Read more...

Your Price

$10.65

In Stock

Indicator Light Lens

★★★★★

(5)

PartSelect Number PS1765368

Manufacturer Part Number 318228310

This is a red indicator light lens for an oven that covers the indicator light for the surface element. The indicator light signifies when the element is on and heated. This part is sold individually. It is recommended to check other red indicator lights in case they need to be replaced because they often wear at the same rate. It is difficult to see the light without the red lens. This part does not include the light. If your light does not illuminate, you may want to consider ordering the light as well. Tools required for this repair are a 1/4 inch nut driver and a stubby Phillips screwdriver.

Installation Instructions

Carol from Houma, LA

Lens missing for burner "on" indication

Lifted the oven top, removed the controls cover, slipped the lens into the hole and slid the light holder device onto the lens Read more...

Your Price

$37.27

In Stock

Oven Light Socket

★★★★★

(4)

PartSelect Number PS439060

Manufacturer Part Number 316116400

The oven light socket allows you to screw in a light bulb so that you can see the inside of your oven. The light socket is located in the back of your oven, so you will need to remove the back panel to access the socket for the repair. You will also need to remove the current light bulb and the light lens cover so that the old socket can be removed. As you will be working around electrical circuits for this repair, be sure to disconnect the power source from the oven before you begin work on the oven.

Installation Instructions

Paul from Spokane Valley, WA

Oven light receptacle broken - bulb base broke off

Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snapped in easily from inside the oven as well. Replaced wiring, installed new bulb, restored power & tested. Replaced back cover. Good time to vacuum under/behind where the oven usually lives before sliding it back to the wall. Read more...

Your Price

$35.90

In Stock

Light Indicator - 125v

PartSelect Number PS436960

Manufacturer Part Number 316022500

Your Price

$11.02

In Stock

LENS

PartSelect Number PS1765367

Manufacturer Part Number 318228301

Your Price

$34.32

In Stock

Light Bulb

PartSelect Number PS3502557

Manufacturer Part Number 318946500

Your Price

$38.24

In Stock

Burner Indicator Light

PartSelect Number PS1765360

Manufacturer Part Number 318044827

Installation Instructions

Homer from Gladstone, VA

indicator light burned out

First you must disconnect power by throwing the circuit breaker off.You need to pull knobs from cook top. check underside to see if it is mounted to counter top, mine was not. Then raise the cook top and support bottom with 2x2's. Mine had three main screws in front, one on the sides and two in the back. The other thing you need to do is loosen the metal plates that have two screws on each plate. Three plates in front, two on each side and three in back. Once these are loosen, you can lift the stove top up to reveal the indicator lights. I found it was easier to support the top with a pan or something while working on it. Replace your indicator light and put everything back together.. It really wasn't to bad. Read more...