Frigidaire Range Circuit Boards and Touch Pads

Your Price

$35.67

Overlay - Black

★★★★★

4 Reviews

PartSelect Number PS3502444

Manufacturer Part Number 316419828

NOTE: Overlay only. Control board NOT included.

Fixes these symptoms

Touchpad does not respond
See more...

Installation Instructions

Bill from LONG BEACH, NY

Needed to change electronic control board

Unplug appliance. Removed back plate cover with 1/4" nut driver (6 screws). Removed old control board with Philips screwdriver (4 screws). Pulled out 5 old connectors. Were a little difficult to get out, had to delicately use a flat head screwdriver to pry loose as not to break the connector. Installed new overlay on new control board (I recommend getting a new overlay and not using the old one, its easier). Reinstalled new control board with 4 screws. Reconnected the 4 connector parts. Installed back plate cover 6 screws. Plugged in and all worked. Read more...

Your Price

$382.27

Electronic Control Board

★★★★★

3 Reviews

PartSelect Number PS9494056

Manufacturer Part Number 5304495521

Board only. Overlay is NOT included.

Fixes these symptoms

Little to no heat when baking
Touchpad does not respond
See more...

Installation Instructions

Gregory from SEFFNER, FL

Couldn't get the oven to work and had a constant beep. Unplugged it.

Followed the instructions that came with control board. The new contol kit came with a upgrade, which I think to help keep this from happening again. Very easy repair to do. Read more...

Your Price

$160.23

Oven Electronic Control Board

★★★★★

9 Reviews

PartSelect Number PS12114577

Manufacturer Part Number 5304509493

Fixes these symptoms

Element will not heat
Little to no heat when baking
Oven is too hot
See more...

Installation Instructions

Larry from BIG STONE GAP, VA

Runaway oven temp

After replacing the oven temp sensor, with no success of correction, i purchased and installed the electronic control board. After turning off the power at the breaker and unplugging the stove, I simply removed the top back cover, unclipped the wiring harness, unhooked the 5 oven element wires(writing the color and order for easier reconnection), removed the screws, carefully peeled the face plate off the old control board and re-installed everything in reverse order. Took me all of ten minutes and the oven works like new again. Read more...

Your Price

$33.17

Overlay - Black

★★★★★

1 Review

PartSelect Number PS2581726

Manufacturer Part Number 316220725

Installation Instructions

Theodore from PLAINFIELD, NJ

F 10 code OvenClock/Timer

After watching video on YouTube. It was very easy. I remove 6 screws from back panel then disconnect wires from clock removed 4 screws from clock. Replace new Clock put 4 screws.6 screw on panel. Plug in Gas Range. Job completed. Read more...

Your Price

$338.28

Oven Electric Control Board

★★★★★

3 Reviews

PartSelect Number PS9494055

Manufacturer Part Number 5304495520

Fixes these symptoms

Element will not heat
Little to no heat when baking
Little to no heat when broiling
See more...

Installation Instructions

Vic from LACEY, WA

Runaway heating during warmup

Initially replaced the thermostat and the problem continued. Website was spot-on with follow-up procedures and ordered the ECB. Installation was simple. Of particular note is that the digital touch pad from the old unit must be removed and reinstalled on the new one BEFORE you install it. Remove the old touch pad carefully as the sticky backing will peel off the black paint on the back of the touch pad and reveal the circuitry board on the new ECB. Other than that, the process was a simple "plug in and go" install. Super easy! Read more...

Your Price

$41.04

Overlay - Black

PartSelect Number PS2581771

Manufacturer Part Number 316419141

This is the overly only. Control board is NOT included. Black in color. Genuine OEM part.

Fixes these symptoms

Touchpad does not respond
See more...

Installation Instructions

Robert from Slidell, LA

Bake element blew out

Removed and replaced bake element. Discovered that oven control module had also blown out. Ordered and replaced new control unit. Stove placed back in service. Read more...