Frigidaire Dryer Thermostats
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Frigidaire Dryer Thermostats
Your Price
$56.00
In Stock
Frigidaire Dryer High Limit Thermostat
PartSelect Number PS446428
Manufacturer Part Number 3204267
This high limit thermostat is used in a dryer and monitors the temperature to make sure it does not exceed 260 degrees Fahrenheit. When your dryer temperature reaches 260 it will cut it out and only comes back when it drops by at least 70 degrees Fahrenheit. If your dryer is overheating, taking too long to dry clothes, or is not producing enough heat, replacing the thermostat could be the solution to your problem. The tools needed for this part are a Phillips screwdriver, putty knife, and needle nose pliers. Refer to the manual provided by the manufacturer for installation instructions and guidance.
Fixes these symptoms
- Not Heating
- Too hot
- See more...
Installation Instructions
MELISSA from OKEECHOBEE, FL
dryer does not get very hot, takes two cycle's to dry
removed the screws, disconnected the wires. installed the new elements replaced the wires.
Read more...
Your Price
$45.54
In Stock
Frigidaire Dryer High Limit Thermostat - L200-70f
PartSelect Number PS2367796
Manufacturer Part Number 137116700
Your Price
$45.03
In Stock
Frigidaire Dryer Cycling Thermostat - 4 Terminal
PartSelect Number PS417453
Manufacturer Part Number 131298300
This operating or cycling thermostat is used in dryers to monitor and direct the temperature inside the dryer. If your thermostat is shorted out and it will not allow the heat to come on, it is best to replace it. The tool needed for this repair is a 1/4 inch nut driver. The first step for this repair is to access the back panel and remove the screws. Next, remove wires connected to the thermostat and remove the screw to pull out the thermostat. Now you can install new thermostat. For further installation instructions, refer to the diagram provided by the manufacturer. As a safety precaution, remember to unplug your appliance from the power source before starting this repair.
Fixes these symptoms
- Too hot
- See more...
Installation Instructions
Patrick from Humble, TX
squeeking/ grinding really bad
First I pryed up the top cover then opened the access cover on the rear to remove the belt from the drum. Next I removed the front of the dryer to have access to remove the drum. I then removed the 3 screws that hold the drum to the rear drum bearing assembly and pulled the drum through the front of the dryer. I then removed the bearing and proceded to remove the ground ball and reassembled in reverse steps.
Read more...
Your Price
$64.30
In Stock
Your Price
$49.95
In Stock
Frigidaire Dryer High Limit Thermostat - L180f
PartSelect Number PS8691862
Manufacturer Part Number 137515200
This part will shut off the electrical power to the dryer if the dryer overheats.
Your Price
$69.25
In Stock
Your Price
$95.99
On Order
Frigidaire Dryer Cycling Thermostat
Once your in, the sensor, thermostat, and igniter are right up front. Sensor and thermostat were easy, the igniter breaks very easily...how do I know? Cause I broke the one I bought and had to get a new one.
I also replaced the coil set for the gas valve, because I had read that they can go bad and cause a gas fume smell. The coils are cheap, so you may as well as do them at the same time.
Anyway, once the repair was complete, I reassembled the unit and hooked up the vent.
Runs like new, and the clothes dry quickly. Read more...
PartSelect Number PS419279
Manufacturer Part Number 134048900
This thermostat controls the internal drying temperature.
Installation Instructions
Dirk from Sonoma, CA
dryer won't stay hot, gas smell
Pulled unit out from wall to access back panel. Top needs to be removed to get to the screws that hold on the front panel and door. These need to be removed to get to the valve and burner. Once your in, the sensor, thermostat, and igniter are right up front. Sensor and thermostat were easy, the igniter breaks very easily...how do I know? Cause I broke the one I bought and had to get a new one.
I also replaced the coil set for the gas valve, because I had read that they can go bad and cause a gas fume smell. The coils are cheap, so you may as well as do them at the same time.
Anyway, once the repair was complete, I reassembled the unit and hooked up the vent.
Runs like new, and the clothes dry quickly. Read more...
Your Price
$52.42
Special Order
Your Price
$143.51
Special Order
Frigidaire Dryer Safety Thermostat - L180-40f
PartSelect Number PS474188
Manufacturer Part Number 5308015399
Your Price
$63.95
In Stock
Frigidaire Dryer Thermostat
PartSelect Number PS418429
Manufacturer Part Number 131658100
This thermostat heater assembly is used for dryers and is attached to the operating thermostat. The function of this part is to automatically regulate temperature and make sure the dryer does not overheat. If any of the following symptoms occur, replacing the thermostat can be the solution to your problem: clothes are still damp, dryer not shutting off when the timer goes off, or your dryer overheats. Remember to unplug your appliance from the power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.
Related Frigidaire Dryer Parts
- All Frigidaire Dryer parts
- Frigidaire Dryer Brackets and Flanges
- Frigidaire Dryer Circuit Boards and Touch Pads
- Frigidaire Dryer Doors
- Frigidaire Dryer Elements and Burners
- Frigidaire Dryer Hardware
- Frigidaire Dryer Hoses and Tubes
- Frigidaire Dryer Knobs
- Frigidaire Dryer Panels
- Frigidaire Dryer Seals and Gaskets
- Frigidaire Dryer Switches
- Frigidaire Dryer Timers