Quick Question!

Have you ever purchased from PartSelect.com before?

Popular Electrolux Refrigerator Parts

Your Price
$60.81
Water Inlet Valve
PartSelect Number PS7784018
Manufacturer Part Number 242252702
The water inlet valve is also known as the water inlet valve assembly and is compatible with your refrigerator. The function of this part is to release water from the supply line when activated, and send it through to your water dispenser in your refrigerator. To make this repair you will need an adjustable wrench, a quarter inch nut driver, and a sharp utility knife. Before you begin this repair make sure to disconnect the power supply to your refrigerator, as well as disconnect the inlet water supply from the back of the refrigerator. Note that this part may appear different than the original, but is an authorized manufacturer replacement.
Fixes these symptoms
Ice maker dispenses too little ice
Ice maker not making ice
Ice maker won’t dispense ice

See more...
Installation Instructions
Jose from Alexandria, VA says,

water leaking out of refrigerator
In my specific appliance the water valve is located in the bottom right hand corner looking at it from the back. To get to it I remove the thin layer of cardboard the covers the back of the fridge. I...read more

Your Price
$4.15
Crisper Cover Support - Front
PartSelect Number PS2358880
Manufacturer Part Number 241993101
This crisper cover front support is used to keep the crisper shelf in place, and may need replacing if the door will not open or close. This part can be used for the front support and mounts to the inside cabinet wall. Replacing this part is an easy repair, but will require a small flat blade screwdriver, a putty knife, and a soft hammer. Remove the crisper and shelf from the refrigerator before replacing the support. The crisper cover front support is held in place with a locking pin. To remove the old part, you will first need to push the pin into the interior of the cabinet using the screwdriver, and then you can pull the support out with a putty knife. After removing the pin and attaching the new support, simply use the soft hammer to lock the new pin in place.
Fixes these symptoms
Door won’t open or close


Installation Instructions
Peter from Amherst, NY says,

Support studs were broken
Used pliers to remove the residual broken stud that was still attached to the wall of the refrigerator, and then just pushed the new part in place. The longest time was spent in removing the food an...read more

Your Price
$4.33
Crisper Support - Rear
PartSelect Number PS2358879
Manufacturer Part Number 241993001
Replacing the rear crisper support in your refrigerator is an easy job, but to complete this repair you will need a small putty knife, a punch or a short flat blade screwdriver, and a small hammer. You may need to replace your rear crisper support if you find that the door will not open or close. In order to complete this repair, you will need to remove all the shelves above the crisper in order to have ample room to work. This part is made from plastic and mounts on the inside of the wall. It is also good to have duct tape on hand, which can be used to protect the liner around the support. This part is sold individually.
Fixes these symptoms
Door won’t open or close


Installation Instructions
Peter from Amherst, NY says,

Support studs were broken
Used pliers to remove the residual broken stud that was still attached to the wall of the refrigerator, and then just pushed the new part in place. The longest time was spent in removing the food an...read more

Your Price
$17.10
Air Filter
PartSelect Number PS1993820
Manufacturer Part Number EAFCBF
This air filter system for refrigerators eliminates odors and any impurities. It does this by neutralizing and removing odor-causing molecules. For best results, it is important to change the filter every 6 months to ensure that food is kept fresh, and the humidity is controlled. This part measures about 7 inches wide and 5 inches deep. Follow installation instructions provided by the manufacturer when installing this part to ensure accurate results and further guidance. Remember to unplug refrigerator from power source before starting this project.
Fixes these symptoms
No Symptoms for this part
Your Price
$100.41
Ice Maker with Cover - 8 Cube
PartSelect Number PS10057209
Manufacturer Part Number 241798224
This Frigidaire ice maker includes the ice mold and control device. The ice maker receives water from the water inlet valve and stores water in the ice mold until it freezes. Ice is automatically ejected and the process continues until the storage bucket is full. Your ice maker should be replaced if ice is not being generated, stored, dispensed, or the ice maker has been damaged. Replacing the ice maker is an easy job and only requires a 1/4 inch nut driver. Before you start this repair, make sure your refrigerator is unplugged. For help with this installation, check out the video below.
Fixes these symptoms
Ice maker not making ice
Ice maker won’t dispense ice


Installation Instructions
Juan from Miami, FL says,

Broken ice maker
Unplugged faulty ice maker, removed two screws holding it to the refrigerator and took it out. Reversed the operation with the new ice maker and after a few minutes presto, we have ice....read more

Your Price
$14.48
Defrost Thermostat Kit
PartSelect Number PS469522
Manufacturer Part Number 5303918214
If you find that there is excessive frost in your freezer, or the freezer will not defrost, you may need to replace the defrost thermostat. The defrost thermostat kit comes with the clip, leads, and heat shrink. To access the defrost thermostat for this repair, you will need to remove your freezer shelves, as well as the back panel of your freezer. To complete this repair, you will need a 1/4-inch nut driver, a set of wire strippers and crimpers, and a heat gun or blow dryer. Before you begin this repair, be sure to disconnect the power source from the appliance.
Fixes these symptoms
Freezer not defrosting
Freezer section too warm
Freezer too cold

See more...
Installation Instructions
Leo from Bentonville, AR says,

Running but not cooling off and frost in the back of the freezer
Unplugged the refrigerator. Removed the 4 hex head screws on the lower back panel at the back of the freezer. Used a blow dryer to defrost the pipes and area surrounding the thermostat. Unplug the ...read more

Your Price
$31.27
Dispenser Crusher Housing
PartSelect Number PS2378689
Manufacturer Part Number 241885001
This dispenser crusher housing may also be known as a refrigerator ice crusher housing, and is compatible with your refrigerator. The function of the dispenser crusher housing is to shield the ice crushing blades within the ice container. To make this repair you will need a Phillips screwdriver, a flat blade screwdriver, a quarter-inch nut driver, and a pair of channel lock pliers. For this installation, work gloves are recommended. Note that this piece may look different or be a different color than the original, but this part will fit and function in the same way as the original part.
Fixes these symptoms
Ice maker dispenses too much ice
Ice maker not making ice
Ice maker won’t dispense ice

See more...
Installation Instructions
Lawrence from Wichita, KS says,

The plasticdrum was broken and would no longer crush or feed the ice through the door
removed screws,removed broken parts and installed new parts....read more

Your Price
$105.86
Rear-Mount Ice Maker Assembly
PartSelect Number PS1992700
Manufacturer Part Number 5303918344
This kit includes the ice maker, power cord, bail arm, and fill cup. If your ice maker is not making or dispensing ice, or you notice a leak, you may need to replace the rear-mount ice maker assembly. This ice maker mounts to the back panel in the freezer section of the side-by-side refrigerator. If you are having an issue with the arm of this kit hitting the shelf, you will have to replace the shelf. You can find the shelf by searching PS1152582. To complete this repair, you will need a 1/4-inch nut driver and a small flat blade screwdriver.
Fixes these symptoms
Ice maker dispenses too little ice
Ice maker not making ice
Ice maker won’t dispense ice

See more...
Installation Instructions
Kenneth from Aurora, IL says,

Icemaker made ice but would not release them from the ice mold
Simply swapped out the entire icemaker, works like a charm...read more

Your Price
$8.59
LIGHT BULB
PartSelect Number PS1527533
Manufacturer Part Number 297114000
This light bulb is used on the inside of your refrigerator or freezer. It is blue in color.
Fixes these symptoms
No Symptoms for this part
Your Price
$29.21
Evaporator Fan Blade
PartSelect Number PS473177
Manufacturer Part Number 5308000010
This evaporator fan blade is a genuine OEM part that is sourced directly from the manufacturer. The evaporator fan blade circulates air through the refrigerator to control the amount of cold air goes that goes to internal compartments of the unit. It may need to be replaced if the fridge is noisy or not cold enough. This part is made of plastic and is sold individually. It will be necessary to disconnect power to the refrigerator and empty the freezer compartment of the refrigerator. The tools needed to complete this repair are a 1/4 inch nut driver and a pair of needle nose pliers.
Fixes these symptoms
Fridge too warm
Noisy


Installation Instructions
Jordan from Maumee, OH says,

Noisy fan
1. Removed the 7 nuts using the nut driver from the freezer back panel inside the freezer.
2. Remove the back panel. The evaporator motor and fan are located above the coils.
3. Unplug the w...read more