Dryer Hoses and Tubes

Your Price

$21.32

Inlet Hose - 5 FT

★★★★★

3 Reviews

PartSelect Number PS11746820

Manufacturer Part Number WP89503

This hose can handle hot or cold water and is five feet long.

Fixes these symptoms

Leaking
See more...

Installation Instructions

Helen from NASHUA, NH

Leaking water inlet hoses.

Removed the old hoses and screwed on the new hoses. Read more...

Your Price

$10.68

Plastic Tube Insert

PartSelect Number PS11747809

Manufacturer Part Number WPA3223101

Sold individually.

Fixes these symptoms

Leaking
See more...

Installation Instructions

Richard from Yarmouth, ME

Leak at fill tube

Removed two screws that held cover plate. remove cover plate. Remove water hose, and clamp, by compressing clamp with pliers. Remove fill tube by pulling HARD, from back.

Replace fill tube, check to be sure that it entered ice maker properly. Replace hose and clamp.
Replace cover and screws. Read more...

Your Price

$83.21

Feed Tube with 3rd Level Spinner

★★★★★

11 Reviews

PartSelect Number PS11748131

Manufacturer Part Number WPW10077859

Also known as the water supply tube.

Fixes these symptoms

Not cleaning dishes properly
See more...

Your Price

$25.13

Extension Hose

PartSelect Number PS334681

Manufacturer Part Number 285863

This part is used to extend washing machine drain hose approximately 4 feet. You may also require the connector (PartSelect Number PS334663) to connect the extension to the existing drain hose.

Fixes these symptoms

Leaking
See more...

Your Price

$23.44

Tub to Pump Hose

PartSelect Number PS3501457

Manufacturer Part Number WH41X10280

Fixes these symptoms

Leaking
See more...

Your Price

$57.75

Water Pressure Hose - Cut-to-Fit

★★★★★

2 Reviews

PartSelect Number PS11741846

Manufacturer Part Number WP353244

This is the hose that tells your appliance if your tub is at the desired water level.

Installation Instructions

Marni from Buhl, ID

water overflowing when filling

I ordered the parts at a minimal cost compared to the repairman's quote, they arrived in 3 days. I used the laptop and put it right next to where I was working so that I could follow the directions step-by-step. The instructions were easy to follow and showed you right what to do so I never had any questions. My washer had a slightly different configuration but I figured it out. Replacing the parts was simple, take one off, put the other on. Putting the washer front back on was a little tricky, I had to have my daughter help me hold it in place while I wiggled it around to make sure it was just right before I screwed it back together. It was easier than I thought it would be. I told my husband I loved the internet, I would never have been able to do this job without the instructional video. Thanks PartsSelect! Read more...

Your Price

$39.86

Inlet Hose Kit

★★★★★

1 Review

PartSelect Number PS2016880

Manufacturer Part Number 202860

This hose is almost 5 feet long and now comes with the washers for proper installation. It is used to bring water into your washer for the cycles.

Fixes these symptoms

Leaking
See more...

Your Price

$15.79

Hose Clamp Kit

★★★★★

2 Reviews

PartSelect Number PS270806

Manufacturer Part Number WH1X2036

This is a water hose clamp kit for a variety of appliances including dishwashers and washers. This is a genuine replacement part. The kit includes two hose clamps. The smaller of the two is 1 inch in diameter while the larger one is 2 inches in diameter. The hose clamps secure the end of the water hose in place to prevent the hose from leaking. If you notice leaking from the hose of your appliance, you may need to replace this kit. Protect your hands with work gloves during this repair to avoid injury.

Fixes these symptoms

Leaking
See more...

Installation Instructions

Richard from Garden City, NY

washer had heavy wet clothes left after spin cycle

The trick is to pull the front cover off by using a putty knife .slide it under the cover at both front corners.it will click on each corner.then pull front cover off .lift off the bottom catch hooks.look for the pump on the bottom right side.unplug the wite connector .take 2-5/16 bolts out holding the bracket.then grab a pliers .squeeze the hose clamps and pull the 2 hoses off.assemble new pump. Read more...