Dryer Brackets and Flanges

Your Price

$17.94

In Stock

Lint Filter Slide

★★★★★

(13)

PartSelect Number PS11772026

Manufacturer Part Number WE01X25915

This is a replacement lint filter slide for your dryer. It is approximately 14 inches long and 5 inches wide. It is made of white plastic and is sold individually. The slide mounts to your dryer and allows the lint filter to slide out for cleaning. If your lint filter will not slide out properly, you may need to replace the slide. This part is an authentic OEM part sourced directly from the manufacturer.

Your Price

$11.09

In Stock

Dryer/Washer Stacking Kit

★★★★★

(1)

PartSelect Number PS470320

Manufacturer Part Number 5303937141

Installation Instructions

Grover from Kennett Square, PA

needed to stack dryer on top of washer

The directions provided were excellent. I just had to remove the washer top, two brackets on the front of the washer and replace with the provided brackets, and finally put back brackets back on the washer. Getting help, I than placed the dryer on top of the washer lining up the brackets and screwed the front brackets together. Read more...

Your Price

$38.59

In Stock

Stacking Kit

★★★★★

(1)

PartSelect Number PS990537

Manufacturer Part Number 8572546

This kit allows you to stack your washer and dryer to maximize your laundry space.

Your Price

$20.53

In Stock

Filter Guide

PartSelect Number PS3524628

Manufacturer Part Number 4974EL1002B

This genuine OEM filter guide keeps garments from exhaust air duct and lint screen inside the dryer. The filter guide is made of high quality plastic and is approximately 15 inches long by 3 inches wide. If your filter guide is faulty, or damaged clothes can get stuck in the lint screen which can cause damage to your garments and to the dryer unit itself.

Your Price

$41.34

In Stock

Stacking Kit

★★★★★

(6)

PartSelect Number PS888067

Manufacturer Part Number 8541503

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

Installation Instructions

Randy from Brentwood, CA

Placing Dryer on Top of Washing Machine with Stack Kit

I purchased a stack kit from "Part select.com". The item was just what I needed to do the job. The delivery of the part was made the next morning. WOW! Excellent service! The process was completed in less than 24 hours, start to finish. Very impressed! Read more...

Your Price

$54.80

In Stock

STACK KIT FOR LONG VENT DRYER

★★★★★

(1)

PartSelect Number PS12069913

Manufacturer Part Number W10869845

Installation Instructions

Nelson from Middletown, NY

Washer Would Drain But Not Spin

Removed rear cover (6 screws) unpluged harness from motor control and removed same. Replaced motor control reinstalled harness. Replaced rear cover. Parts used motor control board. Read more...

Your Price

$17.19

In Stock

Bearing Retainer

PartSelect Number PS266696

Manufacturer Part Number WE1M300

There is a slot in it for a ground strap.

Fixes these symptoms

Noisy
See more...

Installation Instructions

Kerry from New Martinsville, WV

Noisy like a chain rattling inside

Disconnect Power from the Dryer
Remove 2 screws that held the top on the dryer.
Removed the 2 screw that held the front on the dryer.
Unhooked the belt from the tensioner and motor pulley.
Pulled the drum out. Removed the belt.
Removed the three screws that held the bearing assembly
on the back of the drum.
Removed the keeper o-ring slide the bad bearing off of shaft. Slide the new bearing on the shaft put the new o-ring on the shaft. Reassembled the bearing on back of the drum. Put belt back around the drum and put drum back in place. Put The belt around the motor pulley and tensioner
(this is probably the hardest part).
Put the front and top back together.
Turned the power back on. Job done Read more...

Your Price

$6.12

In Stock

Holder

★★★★★

(1)

PartSelect Number PS3524207

Manufacturer Part Number 4930EL2004D

Your Price

$19.81

In Stock

SHAFT & BRACKET Assembly