Crosley Refrigerator Hoses and Tubes

Crosley Appliance Parts
Shop By Part Type

Popular Crosley Refrigerator Hoses and Tubes

Your Price
$25.05
  In Stock
P-Trap Drain Tube Kit
★★★★★
★★★★★
(24)
PartSelect Number PS8691807
Manufacturer Part Number W10619951
The p-trap drain tube kit may also be known as the duck bill, or the drain pipe, and it is compatible with your refrigerator. The function of the p-trap drain kit is to carry the water that has formed during the defrost cycle to the bottom of the refrigerator, where your drain pan is located. The tools you will need for this repair include a 1/4-inch nut driver and a small flat-blade screwdriver. To do this repair you will need to pull the refrigerator forward in order to reach the lower access panel at the back. This kit includes the tube extension piece and spacer.
Fixes these symptoms
  • Freezer not defrosting
  • Fridge too warm
  • Frost buildup
  • See more...
Installation Instructions
Jack from DINUBA, CA
Water leaking from bottom of refrigerator onto floor
The video on website is very good and explains everything in detail. Just follow the directions. This is EASY!!!! Read more...
Your Price
$8.97
  In Stock
Ice Maker Water Fill Tube Kit
★★★★★
★★★★★
(19)
PartSelect Number PS11739222
Manufacturer Part Number WP2196157
The icemaker water fill tube provides water to the icemaker so it can produce ice and dispense water. If you notice that your ice maker is not making or dispensing ice, or is leaking, you may need to replace the water fill tube. This water fill tube kit comes with a fill tube and a compression nut. This part is made of white plastic and is approximately 10 inches in length. The ice maker water fill tube is in the rear of the fridge. To complete this repair, you will need a 1/4 inch nut driver and a utility knife. Before beginning this repair, you may want to disconnect the water and power supply to the refrigerator.
Fixes these symptoms
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • Leaking
  • See more...
Installation Instructions
Charles from Orland Hills, IL
Broken elbow on icemaker water fill tube.
Removed 2 screws holding water fill tube to rear of refrigerator and pulled out, matched old part with new to make sure of proper match. Guide new fill tube thru hole, making sure it is aligned with slot in ice cube tray on inside of freezer. Install new plastic line from water pump outlet to water fill tube, check for leaks, job done. Read more...
Your Price
$44.37
  On Order
Filter Inlet Water Tube
★★★★★
★★★★★
(11)
PartSelect Number PS886401
Manufacturer Part Number 8201597
As per the manufacturer, this part starts out as 1/4" tubing but ends up at 5/16".
Fixes these symptoms
Installation Instructions
George from Hernando, MS
Pur Water filter ruptured could not remove from housing
Removed two screws holding the filter housing. Pulled filter and housing out far enough to remove inlet and outlet lines.Replaced inlet and outlet lines( precautionary) in filter housing, installed new filter. Read more...
Your Price
$24.24
  In Stock
Water Tube Kit
★★★★★
★★★★★
(6)
PartSelect Number PS11730901
Manufacturer Part Number W10823511
This is the replacement water tube kit for your refrigerator. This tubing is made of plastic, is 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube, and may need to be cut. This water tube transports water to the ice and water dispensers. If your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
  • Ice maker not making ice
  • Leaking
  • Not dispensing water
  • See more...
Installation Instructions
Trent from Tacoma, WA
water dispenser started leaking
i wasn't sure it was the inlet valve unit because the leak was at the water dispenser in the freezer door. after some research it looked like the water inlet valve located in the back lower part of the refrigerator was the problem. to replace, take off the cardboard cover, about 6 screws, you have access to the water inlet valve, disconnect the hoses (i think it goes without saying that you should have turned off the water to the frig) replace the inlet valve, connect hoses, turn water back on and you'll be back in business. very easy repair. Read more...
Your Price
$27.53
  Special Order
Ice Maker Fill Tube Assembly
PartSelect Number PS6448034
Manufacturer Part Number 241850615
This supply's water to the icemaker and dispenser.
Installation Instructions
Sam from Ravenswood, WV
Not making ice
Took out old replaced with new. Now it makes ice Read more...
Your Price
$39.36
  On Order
Water Tube
PartSelect Number PS429430
Manufacturer Part Number 218976409
Plastic tube, 5/16".
Fixes these symptoms
Installation Instructions
James from New York, NY
Water was leaking from the valve/pump for the icemaker
Remove the screws that hold the old valve to the side of the refrigerator. Next, detach each plastic tube and attach that tube to the same place on the new valve, and repeat (there are many valves). Afterward, I realized that many of the plastic tubes had become brittle and had mineral deposits, so I bought additional tubing for ice makers and replaced each tube, one at a time. Read more...
Your Price
$12.49
  On Order
Water Tube
★★★★★
★★★★★
(1)
PartSelect Number PS7783975
Manufacturer Part Number 241796405
This is a water fill tube which is used in refrigerators. It attaches to the water inlet valve and supplies water to the components in your appliance that need it, such as the icemaker and water dispenser. You will need to replace your fill tube if you notice it is leaking or damaged. This replacement tube is approximately 7 inches in length, and it is made entirely of plastic. The fill tube is sold individually. Before you begin repairing your refrigerator, make sure the water supply has been turned off and that the appliance has been unplugged.
Fixes these symptoms
Installation Instructions
James from New York, NY
Water was leaking from the valve/pump for the icemaker
Remove the screws that hold the old valve to the side of the refrigerator. Next, detach each plastic tube and attach that tube to the same place on the new valve, and repeat (there are many valves). Afterward, I realized that many of the plastic tubes had become brittle and had mineral deposits, so I bought additional tubing for ice makers and replaced each tube, one at a time. Read more...
Your Price
$53.44
  In Stock
Water Dispenser Fitting and Tube Assembly
★★★★★
★★★★★
(6)
PartSelect Number PS886371
Manufacturer Part Number 8201537
Anti drip valve NOT included.
Fixes these symptoms
Installation Instructions
Conrad from Tucson, AZ
The Water Dispensor Tubing Had Become Brittle And Broke .
Removed the face plate. Removed a few screws and unpluged a few electrical connectors and pulled apart. Removed the holding bracket and clear tubing from door. Cut new tubing at an angle to push through conduit. Reinstalled new bracket and re-installed electrical connectors. Snapped face trim on and bleed air out of system. . Water ran great. Read more...
Your Price
$21.78
  In Stock
Water Tube Connector/Union - 5/16 to 5/16
★★★★★
★★★★★
(1)
PartSelect Number PS11740187
Manufacturer Part Number WP2300868
Sold Individually. - * Part may differ in appearance, but functions same as original.
Fixes these symptoms
Installation Instructions
Leo from Salem, SC
Had to replace a hose connector at the base of my refrig/frreezer
Perhaps a helpful hint:

When aI received the hose adapter/connector, I inserted the 2 hose ends only to have water drip from the connection.
I used a utility knife to remove an inch from each side, then reinserted the hoses. That made the differnce. Dry as a bone.

LG
Read more...
Your Price
$10.86
  In Stock
Compression Nut
★★★★★
★★★★★
(1)
PartSelect Number PS11743305
Manufacturer Part Number WP627018
The compression nut is used as a connection between the water supply line and other components in your refrigerator such as your ice maker and your water dispenser. Tools required for this repair include a pair of pliers and a socket set. Before installing this part you should take all perishable foods out of your refrigerator and store them somewhere cool, unplug the refrigerator from the power source, and shut off the water supply. This repair may require you to wear work gloves to protect your hands, and is considered an easy do-it-yourself fix.
Fixes these symptoms
Installation Instructions
harry from murfreesboro, TN
Water leaking from bottom of fridge
The line going from the ice maker fill valve ruptured and leaked water on the floor. The outlet fitting for the ice maker water inside the freezer was plugged with ice which caused the pressure to build up in the line and rupture it. The discharge tube inside was full of ice because the ice maker fill valve was old and was leaking ever so slightly. This allowed water to exit into the discharge tube gradually and build up ice to the point of blocking the discharge tube. Read more...

Related Parts