Crosley Refrigerator Dispensers

Crosley Appliance Parts
Shop By Part Type

Popular Crosley Refrigerator Dispensers

Your Price
$19.26
  In Stock
Ice Guide
★★★★★
★★★★★
(54)
PartSelect Number PS11739026
Manufacturer Part Number WP2180224
This is a refrigerator ice guide that is made entirely of clear plastic. This ice guide is located in the freezer door. Turn your refrigerator ice dispenser off before replacing the part. This is a simple repair, and the only tool you will need is a small flat blade screwdriver to push on the pivot tab on the bottom of the ice guide. Do not worry about breaking the side or pivot tabs on your existing ice guide because it will be discarded anyway. This is a genuine manufacturer replacement part.
Fixes these symptoms
  • Door Sweating
  • Ice maker dispenses too much ice
  • Ice maker not making ice
  • See more...
Installation Instructions
Tracy from Jacksonville, FL
External Ice Guide Broke a Tooth and Fell Off
We waited two years to do this because we didn't want to hassle with a repair man to come out and charge us arm+leg for something so simple. Finally we searched and found the part on line. It came two days FASTER than promised. Kudos to Part Select.
Snapping it on was a breeze, although you do have to apply more pressure than feels comfortable with plastic clips. We can know get ice out of the external door system again.
Read more...
Your Price
$41.20
  Special Order
Water Dispenser Actuator
★★★★★
★★★★★
(11)
PartSelect Number PS1526383
Manufacturer Part Number 241682003
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.
Fixes these symptoms
Installation Instructions
Jonathan from Universal City, TX
Water actuator broke
If you think you probably can't do this, you're like me... but you just had to try because you needed the part anyway right? This really was quite simple, a lot easier than it sounds from the description and saved me probably $75 I'd have had to pay a tech to do it. Just unplug fridge, yank that water spill tray out, yes yank, it's a bit hard to do that if you've not done it before. After that remove the 3 phillips head screws you just gained access to. Lift panel frame up then out. Disconnect wire harness plug and set that frame aside. Take out next screws exposed to free the unit. Tilt unit out and remove the two little screws and shims holding actuator in place. Remove broken one. Put new one in. Reverse all actions taken thus far. Plug fridge back in and have a drink of water like nothing ever happened. : ) You can do this! Read more...
Your Price
$71.44
  In Stock
Ice Door Kit
★★★★★
★★★★★
(29)
PartSelect Number PS11723180
Manufacturer Part Number W10823377
In this kit you will find the support, the ice door, spring, and delay. The heater ribbon is no longer needed and therefore will not be included with this part. This kit works in the dispenser chute to let ice through when it is being dispensed. If you have the following symptoms such as: door sweating, difficulty opening or closing door, frost buildup, warm freezer section, or problems with ice dispensing, then this is a solution. The tools needed for this repair are a putty knife, needle nose pliers, and 1/4 inch nut driver. Wear work gloves to protect your hands when performing this repair.
Fixes these symptoms
  • Door Sweating
  • Door won’t open or close
  • Freezer not defrosting
  • See more...
Installation Instructions
BILL from BATESVILLE, MS
Front Door Ice Wouldn't Work And Air Going Into Freezer
Thanks to the pictorial diagram, I was able to order correct parts. It was just a matter of removal of broken parts and replacing them. Ice maker now working and air is no longer getting into freezer which was freezing up ice maker. Thanks for timely delivery, now I am able to use ice dispenser, which I haven't used for long time. Thanks Read more...
Your Price
$38.75
  In Stock
Dispenser Grille
★★★★★
★★★★★
(5)
PartSelect Number PS1148319
Manufacturer Part Number 241649003
This part is the replacement dispenser grille for your refrigerator. It is made of black plastic and is approximately 10 inches wide and 4 inches deep. The dispenser grill sits at the bottom of your ice dispenser assembly and catches any spills when your ice or water dispenser is running. If your dispenser grille/drip tray is missing or damaged, this is the part that replaces it. To replace the dispenser grille, simply remove it and insert the new one. This part is sold individually and is and authentic OEM part sourced directly from the manufacturer.
Installation Instructions
Irene from Perkasie, PA
The actuator arm broke on the unit and it had to be replaced
The actuator arm was the only part that was a little difficult. The drip tray and the kick plate went on very easily. First, we went online to your schematic on the unit. This showed how it was assembled and how it came apart. We then terminated the power to the refrigerator, and removed the drip tray which exposed two screws holding in the face plate for the ice/water on the door of the refrigerator. We then removed three screws from the control panel and pulled it forward. This exposed the actuator and two more screws that held it into place. We removed them and unplugged the small plug giving power to the actuator. We then installed the new part and replaced all the screws that had been removed. We reassembled the face plate and the screws there and then snapped in the drip tray. When we turned on the power everything worked fine. Read more...
Your Price
$51.02
  Special Order
Ice Actuator
★★★★★
★★★★★
(6)
PartSelect Number PS1526380
Manufacturer Part Number 241681903
This is the ice actuator or ice actuator arm for your refrigerator. When you depress the actuator arm with a glass or bucket, ice is normally dispensed. If your current actuator arm is broken, missing, or if the ice dispenser isn’t dispensing ice, you may need to replace it. To access the actuator, you will first need to remove the dispenser assembly, and then remove the actuator from the assembly. Be sure to shut off the water and power source from your refrigerator before you begin this repair.
Fixes these symptoms
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • See more...
Installation Instructions
Ryan from Elk Grove, CA
"Paddle" on ice actuator broke off.
Slide off drip tray at bottom of ice/water compartment.

Remove the 3 screws along bottom edge of face plate. Slide face plate upwards slightly to disengage tabs holding top of face plate to fridge door. Pull face plate slightly away from fridge, reach behind plate, and disconnect wiring harness. Set face plate aside.

Remove 3 screws holding ice/water actuator mechanism to fridge door. Disconnect wiring harness on left side of actuator mechanism. This allows the left side of mechanism to swing outwards.

Looking down on top of mechanism, loosen the two screws holding the small, metal retaining plates for ice actuator. (The metal plates hold the ice actuator pivot pins in place in the actuator mechanism). Once the two screws are loosened, the metal plates can be moved to the side to free the ice actuator.

Remove old ice actuator and replace with new actuator. NOTE: Ensure the black ice door flap regulator (the thing with the gear teeth) stays engaged with the gear on the damping mechanism while installing the new ice actuator).

Move the metal retaining plates back in place over the ice actuator pivot pins and tighten both screws. Move the ice/water actuator mechanism back in place and re-connect the wiring harness on the left side. Re-install the 3 screws holding the entire mechanism in place.

Re-connect the wiring harness to the face plate and slide the tabs at the top of the plate into the holes in the fridge door. Slide face plate down and line up the 3 screw holes at the bottom of plate. Re-install the 3 screws. Re-install the drip tray. You're done!
Read more...
Your Price
$189.42
  In Stock
Dispenser Funnel Guide
★★★★★
★★★★★
(5)
PartSelect Number PS8746715
Manufacturer Part Number 242270102
This dispenser module is for refrigerators. Dispenser module attaches in the dispenser housing on the freezer door and includes the cradle, ice chute and ice chute door. Safely store any food that could deteriorate while the power is off. Unplug the refrigerator before installing this part. Wear work gloves to protect your hands.
Installation Instructions
CHRISTINA from ESCONDIDO, CA
Water dispenser would not auto shut off
I watched a YouTube video and followed along. Easy!! Read more...
Your Price
$16.06
  On Order
DRIP TRAY
★★★★★
★★★★★
(4)
PartSelect Number PS2363822
Manufacturer Part Number 241947003
Your Price
$38.01
  In Stock
Water Dispenser Actuator
★★★★★
★★★★★
(10)
PartSelect Number PS1526381
Manufacturer Part Number 241682001
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.
Fixes these symptoms
Installation Instructions
Robert from North Olmsted, OH
The water dispenser/actuator broke and I wanted to replace it
First I pulled the fridge out and unplugged it. Then I removed the drip tray at the bottom of the water and ice dispenser. This exposed three screws that held the frame of the dispenser mechanism to the freezer door. I removed the three screws and lifted it up a little and I could pull it out and tip it to get at the inside of the dispenser mechanism. I could pull the whole mechanism out a bit, but I was afraid to pull it out too far for fear of unplugging something and tearing or breaking a wire. The water dispenser actuator piece has two round plastic "pins" on either side to allow the actuator to rock back and forth. These "pins" are held in place in a round channel by two metal plates which were in turn held in place by two screws. When I tried to take out these retaining plates, I dropped one of the screws in the dispenser mechanism. I had to fish it out with a magnet. By the way, the plates did not respond to a magnet, so when I dropped one of these, I had to use needle-nosed pliers to fish it out. It took a while, but I finally got the old actuator out and out the new one in and carefully re-attached the retaining plate with their respective screws and re-attached the little spring to the actuator. Before I put it back together, I cleaned off the little door to the ice dispenser. It looked a little crudded up and I just wiped it off with some damp Q-tips. I then put the dispenser mechanism back on to the freezer door, put the screws back, slid the drip tray back, plugged it in and it (surprisingly) works fine. Looking back, I probably should have bought a part for the ice dispenser, too, and replaced that at the same time. Read more...
Your Price
$36.48
  In Stock
Ice Dispenser Door Seal
★★★★★
★★★★★
(1)
PartSelect Number PS1526429
Manufacturer Part Number 241688701
This part works in conjunction with the ice chute door.
Fixes these symptoms
Your Price
$29.85
  In Stock
Overflow Grille - White
★★★★★
★★★★★
(12)
PartSelect Number PS11739625
Manufacturer Part Number WP2206670W
This is a genuine Whirlpool dispenser overflow grille for your refrigerator. This part is made of plastic and snaps in under the water and ice dispensers on your refrigerator door. Its function is to catch drips and spills from the dispenser.

Related Parts