Microwave Oven Repair Guide - Replace turntable cooking tray motor

Replacing a microwave turntable cooking tray motor:

Turntable motor replacement

Replacing a turntable drive motor is a lengthy and involved process that the average layman should not perform. Consult with a certified and experienced appliance repair technician. He or she will have the proper knowledge and skill required to both test and replace a microwave turntable motor.

Find a turntable motor for your microwave oven.

CAUTION: Your microwave oven is capable of giving you a serious electrical shock, even when it is unplugged. We strongly suggest you seek the assistance of an appliance repair technician when conducting any microwave oven repair.

FREE appliance repair advice from the pros!

Oven taking long time to heat
Sat, 11 Oct 2008 21:00:11 GMT
Post By: rayaleman
I have a Kenmore (not sure of the model) gas range and it takes about an hour to reach a high desired temp. It is a pilot free ignition model. Any ideas, thanks in advance. This oven is very old,...

Stove
Sat, 11 Oct 2008 20:32:44 GMT
Post By: walkowg
I have a gas /electric stove that had 480 put to it instead of 240 is it off to the scrap dump or is it posible to fix it right now I have 0.00 in it also have a frig that had 240 put to it instead...

Admiral Fridge-Freezer not working correctly
Sat, 11 Oct 2008 20:32:26 GMT
Post By: mari8247
Okay my Fridge is from the Admiral Designer series and it says it is frostless. It is one of those side by side deals where the Freezer is on the left side and the Fridge is on the right side. One...

Identifying part for Whirlpool Refrigerator water dispenser solenoid
Sat, 11 Oct 2008 20:10:41 GMT
Post By: gaudimila
Side by side, I press the water dispenser and no water comes out, I can hear a faint hum so I know that the solenoid is getting current, and if I wait for a few seconds or keep pressing, eventually...

Hotpoint washer won't spin
Sat, 11 Oct 2008 20:08:32 GMT
Post By: 3fosters
I just replaced the agitator coupling, it was alittle hard going on so I tapped it on with a hammer. Now it won't spin. It agitates during the spin cylce. The tub is pretty tight, I tried to make...

See all our repair forums