Quick Question!

Have you ever purchased from PartSelect.com before?

Popular Westinghouse Appliance Parts

Your Price
$17.15
Bake Element - Push On Terminals - 240V
PartSelect Number PS2332301
Manufacturer Part Number 316075104
This bake element is used in electric ovens and ranges. It can be found in the bottom of the appliance. It supplies the heat required for the baking function. If your element is no longer glowing red, or your oven is not heating properly while the bake feature is being used, the element might be faulty. It features push on male terminals, which are 1/4-inch high temperature spade connectors. The bake element is approximately 19 1/4 inches wide, and it measures approximately 15 inches deep from the front of the element to the bracket. It extends 3 1/2 inches past the bracket to the terminals. Unplug your appliance before you begin any repair work.
Fixes these symptoms
Element will not heat
Little to no heat when baking
Little to no heat when broiling

See more...
Installation Instructions
David from Shawnee, KS says,

Oven woudn't heat
1. Removed two screws, pulled out the element, voltage tested the element and determined it was an open circuit (bad element).
2. Ordered the part from partselect.com
3. Disconnected elem...read more

Your Price
$3.92
Crisper Cover Support - Front
PartSelect Number PS2358880
Manufacturer Part Number 241993101
This crisper cover front support is used to keep the crisper shelf in place, and may need replacing if the door will not open or close. This part can be used for the front support and mounts to the inside cabinet wall. Replacing this part is an easy repair, but will require a small flat blade screwdriver, a putty knife, and a soft hammer. Remove the crisper and shelf from the refrigerator before replacing the support. The crisper cover front support is held in place with a locking pin. To remove the old part, you will first need to push the pin into the interior of the cabinet using the screwdriver, and then you can pull the support out with a putty knife. After removing the pin and attaching the new support, simply use the soft hammer to lock the new pin in place.
Fixes these symptoms
Door won’t open or close


Installation Instructions
Peter from Amherst, NY says,

Support studs were broken
Used pliers to remove the residual broken stud that was still attached to the wall of the refrigerator, and then just pushed the new part in place. The longest time was spent in removing the food an...read more

Your Price
$24.71
Door Bin
PartSelect Number PS429724
Manufacturer Part Number 240323001
Door bins, also known as cantilever shelves, are storage bins located on the door of your refrigerator. Over time, a cold refrigerator can cause plastic to become fragile and break down. This can then lead to possible issues that are easily fixed. A few issues that might arise that would require a repair are: the ice maker not producing ice, an unresponsive touch pad, leaking, loud noise, or issues with opening and closing the door. The repair is very easy and requires no tools. Simply lift and wiggle the bin to remove, line up the plastic mounts on the new bin, and snap into place.
Fixes these symptoms
Door won’t open or close
Ice maker not making ice
Ice maker won’t dispense ice

See more...
Installation Instructions
Erik from Evans, GA says,

Aged parts broken
After sitting in a cold refrigerator for year after year, plastic becomes brittle and breaks. This is what started happening to my shelves and door bins. The problem a lot of times is getting the righ...read more

Your Price
$24.48
Door Shelf Retainer Bar
PartSelect Number PS734935
Manufacturer Part Number 240534901
This door shelf retaining bar, also known as refrigerator door bar retainer or fridge door rack, is a genuine part sourced from the original manufacturer. It is a white plastic part that measures about 25 inches wide, 3 inches high, and 5 inches deep, and is sold individually. The bar attaches to the inside of the refrigerator or freezer door to hold food items on the door shelves. The bar may need to be replaced if it is warped or broken. It is recommended to check other door shelf retaining bars on the fridge to be sure no other bars need to be replaced.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Cynthia from Long Beach, CA says,

The retainer door shelf broke 3 years ago
I just snapped the new shelves in place and !voila! I should've done this years ago....read more

Your Price
$4.31
Crisper Support - Rear
PartSelect Number PS2358879
Manufacturer Part Number 241993001
Replacing the rear crisper support in your refrigerator is an easy job, but to complete this repair you will need a small putty knife, a punch or a short flat blade screwdriver, and a small hammer. You may need to replace your rear crisper support if you find that the door will not open or close. In order to complete this repair, you will need to remove all the shelves above the crisper in order to have ample room to work. This part is made from plastic and mounts on the inside of the wall. It is also good to have duct tape on hand, which can be used to protect the liner around the support. This part is sold individually.
Fixes these symptoms
Door won’t open or close


Installation Instructions
Peter from Amherst, NY says,

Support studs were broken
Used pliers to remove the residual broken stud that was still attached to the wall of the refrigerator, and then just pushed the new part in place. The longest time was spent in removing the food an...read more

Your Price
$13.80
Defrost Timer - 60Hz 120V
PartSelect Number PS423801
Manufacturer Part Number 215846602
Defrost timers are part of the defrost circuit in your refrigerator and freezer. This timer cycles the defrost heater on and off. For every eight hours, the appliance timer will cycle for 30 minutes. The defrost heater is what melts the frost buildup on the evaporator coils, and it can prevent your freezer from frosting up. If your timer fails, the heater will not get the energy it needs to run, and frost will continue to build up. Test the defrost thermostat and the defrost heater with a multi-meter. If they are in working order it is likely that the defrost timer is the faulty component of the circuit and needs to be replaced. Before you begin this repair make sure the appliance has been unplugged.
Fixes these symptoms
Freezer not defrosting
Freezer section too warm
Freezer too cold

See more...
Installation Instructions
Stephen from Warrington, PA says,

Fridge got warm and freezer coils were frosted
Fridge is a side by side. The freezer is pretty narrow for a guy with wide shoulders.

Pulled plug.

Had to remove bottom drawers then used nut driver to remove screws closest t...read more

Your Price
$29.74
Door Shelf Retainer Bar
PartSelect Number PS734936
Manufacturer Part Number 240534701
The door shelf retainer bar is also referred to as a refrigerator door rack. This piece is used as an attachment on the inside of your refrigerator door. The functionality of the refrigerator door rack is that it acts a shelf to hold small items in your fridge, such as condiments. This specific model is easy to replace as it is sold individually and snaps into place in your refrigerator without screws. When installing the door shelf retainer bar you will not need any tools. Users ranked this installation as easy and it takes less than fifteen minutes to do.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Lannie from Buffalo, WY says,

door rack was broken
pulled broke rack off, snapped new one in place. Yeah!! No more broken jars on the floor....read more

Your Price
$59.10
Water Inlet Valve
PartSelect Number PS7784018
Manufacturer Part Number 242252702
The water inlet valve is also known as the water inlet valve assembly and is compatible with your refrigerator. The function of this part is to release water from the supply line when activated, and send it through to your water dispenser in your refrigerator. To make this repair you will need an adjustable wrench, a quarter inch nut driver, and a sharp utility knife. Before you begin this repair make sure to disconnect the power supply to your refrigerator, as well as disconnect the inlet water supply from the back of the refrigerator. Note that this part may appear different than the original, but is an authorized manufacturer replacement.
Fixes these symptoms
Ice maker not making ice
Ice maker won’t dispense ice
Leaking

See more...
Installation Instructions
Jose from Alexandria, VA says,

water leaking out of refrigerator
In my specific appliance the water valve is located in the bottom right hand corner looking at it from the back. To get to it I remove the thin layer of cardboard the covers the back of the fridge. I...read more

Your Price
$33.81
Evaporator Fan Motor Kit - 120V 60Hz
PartSelect Number PS3419839
Manufacturer Part Number 5303918549
The evaporator fan motor circulates air through the food compartment for efficient cooling in refrigerators. The evaporator is located in the back of the freezer and it circulates the air over the refrigerator coils. The evaporator motor fan in your refrigerator should be replaced if the fridge section is too warm, the freezer section is too warm, orthe evaporator motor makes loud noises or stops working completely. The tools used for this repair are a 1/4 nut driver and wire strippers. *Please note: The motor has been updated by the manufacturer. Tip to detect if motor is not working, often if it fails it generates loud noises in the freezer area. For safety, make sure food is safely stored so it does not deteriorate while the power is off, and remember to unplug fridge.
Fixes these symptoms
Freezer section too warm
Fridge and Freezer are too warm
Fridge too warm

See more...
Installation Instructions
Larry from Carthage, NC says,

bottom of fridg. would not get cool. Temp was 50-60degrees. The freezer compartment worked so I knew it was not the compressor.
I removed the fan housing in the freezer section by removing all the screws. (7) There are two screws behind the vents. I did not have an ice maker to contend with so this was very easy. There is onl...read more

Your Price
$15.91
Rear Drum Bearing Kit
PartSelect Number PS459829
Manufacturer Part Number 5303281153
This rear drum bearing kit is designed for use with dryers. It supports the rear of the drum in your appliance as it tumbles your clothes during the drying cycle. If your drum will not tumble, or if it is making a lot of noise, it could be an issue with this part. This is a ball-and-socket style bearing. You will need to replace this if the bushing has worn out, or if the ball support is damaged. This kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant and installation screws. Unplug your dryer before you begin this repair.
Fixes these symptoms
Marks left on clothes
No heat or not enough heat
Noisy

See more...
Installation Instructions
charles from new holland, OH says,

Dryer squealed like a pig and at times the drum stopped rotating
First thought the problem was a stretched drum belt or bad idler pulley. Ordered a new belt and idler assy plus spring. Replaced those items with relative ease following suggestions obtained at this ...read more