PartSelect Number PS2342029
Manufacturer Part Number W10196406
|
Fixes these symptoms No Symptoms for this part
|
Installation Instructions
Linda from Atlanta GA says,
Old drip pans stained
Replaced old drip pans with new ones - very easy - even a 68 yr old lady can do it!!...
read more
|
PartSelect Number PS377754
Manufacturer Part Number 488729
This metallic screw is less than an inch long and comes with a plastic washer.
|
Fixes these symptoms No Symptoms for this part
|
|
PartSelect Number PS347627
Manufacturer Part Number 349241T
These two drum support rollers are no longer available for individual sale. Available in a package of two and it is recommended that you replace both rollers at once. These two rollers come with four tri-rings.
Fixes these symptomsUnusual NoiseWill not startWill not tumble
See more...
|
Installation Instructions
Mark from Fremont NE says,
Wife told me Dryer would make a funny sound, then stop + had an a funny smell as well. The Electric motor that drove the unit was overheating and locking up, It was time to be replace.
The best part of my repair was I had everything back in service in 3 days. And one of these days was to consider just buying a new dryer. Had parts overnited and all parts fit and easy to replace. read more
|
PartSelect Number PS376605
Manufacturer Part Number 482493
This eight-hour defrost timer will replace most other defrost timers. This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater. The best way to make sure you get the correct timer for your refrigerator is to conduct a search for your model number.
Fixes these symptomsFreezer not defrostingFreezer section too coldFreezer section too warm
See more...
|
Installation Instructions
Lawrence from Grahamsville NY says,
The frost free feature of the freezer was freezing over with ice and cooling coils were being insulated with thickening frost which caused the cooling air to rise in temperature from -5 degrees to 20 degrees.
I troubleshot the problem by reading the electrical schematic and concluding the heating elements (defrost cables) were either defective or the bi-metal temp sensor was open. When closed the temp sen...
read more
|
PartSelect Number PS340571
Manufacturer Part Number 330031
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.
|
Fixes these symptoms Cooktop element not heating
|
Installation Instructions
Jonathan from Lilburn GA says,
8 inch burner wouldn't come on. Wires shorted out
One screw holds the block onto the stove top. Had to clean out fitting for phillips screwdriver or screw would have stripped because it was old with lots of buildup. Even cleaned out, this screw requi...
read more
|
PartSelect Number PS383724
Manufacturer Part Number 691366
This part provides the tension required for a multi-ribbed belt. It also serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.
Fixes these symptomsUnusual NoiseWill not startWill not tumble
See more...
|
Installation Instructions
Ray from Denton TX says,
Dryer tub belt broke
Removed the two screws that attatch the lent channel to the top of the dryer, then lifted the top of the dryer by pushing in on the two locking tabs located at the front , left and right , corners of ...
read more
|
PartSelect Number PS2366565
Manufacturer Part Number W10196406RW
This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom.
|
Fixes these symptoms No Symptoms for this part
|
Installation Instructions
Frank from Derwood MD says,
The drip bowls on my elderly mother's electric range needed to be replaced.
Replacing the bowls was simple, simply removing the burner units and pulling out the bowls and inserting the new ones.
The ONLY reason I am answering this questionaire is to complement Pa...
read more
|
PartSelect Number PS1485646
Manufacturer Part Number 285753A
This coupling kit is used between the motor and the transmission on direct drive washers with no belt. This is the newer version and is made with new metal sleeves for added strength.
Fixes these symptomsBurning smellLeaking waterPumps but will not spin
See more...
|
Installation Instructions
Jeff from Wayne NJ says,
No movement from Basket & agitator
The job looked intimidating but turned out to be very easy. First take off the water pump by removing the two clips that hold it in place. Place a shallow pan under the pump to catch the water t...
read more
|
PartSelect Number PS334180
Manufacturer Part Number 279311
This silicone carbide igniter with ceramic holder kit includes the 3" flat igniter, bracket, 5" wire leads, and the plug. Able to replace both round and flat igniters, this kit is used for many gas clothes dryers.
|
Fixes these symptoms No heat or not enough heatWill not start
|
Installation Instructions
TEODY from MILPITAS CA says,
No Heat. Dryer keeps running but no heat to dry clothes.
Repair was very easy. We are in the internet age so I use it all the time to get info on how to repair any thing in the house including cars. This time it was my dryer. I typed up 'Kitchen Aid dryer h...
read more
|
PartSelect Number PS378042
Manufacturer Part Number 489355
This screw is sold individually.
|
Fixes these symptoms No Symptoms for this part
|
Installation Instructions
Ronald from Northfield Center OH says,
changing stove and dishwasher to match new frig.
I actually replaced parts on my black double stove to make it into stainless. We purchased a new frig and needed to replace parts on our stove and dishwasher so they would match. They look beautiful...
read more
|
PartSelect Number PS334299
Manufacturer Part Number 279816
This clothes dryer thermal cut-off kit includes one high limit thermostat with a limit of 250 degrees Fahrenheit, and one thermal cut-off fuse (309 degrees). This kit also includes flat heaters with jumper wires.
Fixes these symptomsNo heat or not enough heatShuts off too soon on auto dryTakes too long to dry
See more...
|
Installation Instructions
John from Indianapolis IN says,
Dryer would take forever to dry clothes, even on high setting
I ordered all the thermal sensors for the dryer. They arrived two days later and they were the correct parts. It took me about 1/2 hour to replace all three sensors and now the dryer works like new ...
read more
|