986832-1-S-Whirlpool-4396841           -Water Filter
986832-1-S-Whirlpool-4396841           -Water Filter 986832-2-S-Whirlpool-4396841           -Water Filter

Water Filter

PartSelect Number PS986832

This Whirlpool filter reduces taste and odor of clorine, small particulates, benzene, toxaphene, lead and mercury. It pushes in the botton front grille. Suggested replacement is every 6 months. Sold individually.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Water dispenser will not dispense water.
  • Ice maker will not make ice.
  • Leaking water.
  • Compare At

    $65.32
  • You Save

    $10.89
  • Your Price

    $54.43
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.3 / 5.0, 15 reviews What's this?
1-15 of 15
 

532 of 949 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyVery Difficult

Time to do repair:30 - 60 mins

Tools

CustomerKate from Jacksonville FL

There were directions

We didn't know where the product went and it was very difficult to install.

Help other customers find the most helpful instructions.

Were these instructions helpful?

194 of 247 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerLeroy from Perkiomenville PA

Six months the light turns red. Time to replace filter

First I shut the water off to the refrigerator.then i pushed the big button in the middle of the grille below the refrigerator door. pulled out the old filter, took the front cap off the old filter put it on the new filter. took the two red caps off the new filter. pushed the filter in till it locked in place. all done! Turned the back on.

Help other customers find the most helpful instructions.

Were these instructions helpful?

89 of 116 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyEasy

Time to do repair:Less than 15 mins

Tools

CustomerVictoria from Beaverton OR

Water filter replacement

It's simple enough in theory: read the side of the box and follow the instructions. BUT you need to really push the knob in pretty hard (I am a girl, and my hand strength isn't that good). If you don't, when you turn the knob, the filter won't come out, then it's tougher. So: make sure the knob pops before you turn!

Help other customers find the most helpful instructions.

Were these instructions helpful?

46 of 60 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerKenneth from SAn Francisco CA

Change the water filter light was on.

It was ridiculously easy. Push the button on the filter canister holder at the base of the refrigerator and the spring-loaded mechanism came out smoothly. I unplugged the old filter, took the cap off the new on and plugged it in. After reinserting the filter canister holder and locking it in place, I heard the whoosh of water once again moving through the filter. Very satisfying and very easy to do.

Help other customers find the most helpful instructions.

Were these instructions helpful?

28 of 40 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerAaron from Liberty Township OH

Washing poorly, leaving particles of food on top of the dishes, not draining completely, ceiling spray arm not spinning (bent up to the ceiling)

The lower spray arm unscrews. From inside the dishwahser, put a screwdriver through the tab slots and unscrew the tower from the floor. It's pretty tight for plastic.
The upper spray arm has screws on the top of the dishwasher. You must slide the dishwasher out from underneath the countertop to get to the screws. Normally that's just the two screws above the door that screw into the countertop. Pull the insulation back and unscrew the arm from the top of the dishwasher. Reverse to reinstall.
Piston and nut assembly for check valve: Inside the dishwasher at the back there are 2 screws that hold a screen down. Remove the screen. Take out the check valve and replace it. It was still functional in mine, it looked like food gunk had built up on it and impeded the check valve action.
The flapper chec is a rubber flap in the drain tube that connects to your sink drain. You have to pull the dishwasher out from under the sink to get to the end of the drain tube that connects to the dishwasher. Take the hose clamp loose and remove the drain tube from the dishwasher. Then unscrew the plastic fitting that you just took the drain tube off of. The flapper chec is there. It had turned brittle and didn't flap anymore. It is a similar setup to the rubber seal at the end of your garden hose.

Help other customers find the most helpful instructions.

Were these instructions helpful?

16 of 23 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerLeslie from Nipomo CA

Water filter needed to be replaced

It was SOOO easy, I turned and popped out the old filter and turned and snapped in the new one....I don't even think it took a whole minute to replace!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

16 of 24 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerDebbie from Tyler TX

Water filter needed replacing

followed the instructions on the box

Help other customers find the most helpful instructions.

Were these instructions helpful?

12 of 18 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerDenise from Hoschton GA

It was just time to replace the water filter.

We took out the old filter and put in the new one. Ran out a few gallons of water then it was ready to use.

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 9 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerScott from Fort Lauderdale FL

Ice maker stopped working.

Removed the icemaker to see if I could determine problem; motor was seized; got part numbers and ordered from you; parts arrived next day (even though overnight delivery wasnt' requested - so THANK YOU!); compared new parts to original to be sure of fit; reassembled unit; reinstalled in freezer, and waited for the sound of water filling the tray. Producing like brand new again! Cancelled the service call w/ Sears for the following week (when it was convenient for them) Loved your service!

Help other customers find the most helpful instructions.

Were these instructions helpful?

7 of 13 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerDavid from port st lucie FL

Water filter

Just put the new one in.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 8 people found this instruction helpful

Parts Used

  • Water Filter

Level of DifficultyDifficult

Time to do repair:15 - 30 mins

Tools

CustomerSandra S from Topeka KS

The wrong filter was sent the first time.

I removed the cap from the filter pushed a lever and removed fliter. I replaced the old filter, removed the caps on the new one and slid it into channel after replacing the outer cap. I removed water from the spigot for 4 mins. and it was ready to go. I pushed the reset button to get the green light to come on.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 5 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:Less than 15 mins

Tools

CustomerJohn from Alpharetta GA

Slide track cracked

removed the old track, replaced with new. snapped into place

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 4 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerMark from Elizbathtown KY

Broken crisper pan and dirty water filter

Very easy to replace

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 6 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

Customerdonna from pelham NY

Shelf broken

slides right in. Water filter just as easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerBruce from mount prospect IL

Ths left and side rail of the snack bin broke

I pulled out the snack bin, took out the shelf, The rails slide and snap out. To install, all you do is snap in and slide the rail in place. 5 minute job.

The filter took 10 seconds

The timer know was for a Kenmore washing machine, and the install took 5 seconds

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-15 of 15