983506-1-S-Whirlpool-9706649           -Speed Control Assembly
983506-1-S-Whirlpool-9706649           -Speed Control Assembly 983506-2-S-Whirlpool-9706649           -Speed Control Assembly

Speed Control Assembly

PartSelect Number PS983506

Used with Stand Mixers.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $53.21
  • You Save

    $8.87
  • Your Price

    $44.34
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 5.0 / 5.0, 2 reviews What's this?
1-2 of 2
 

9 of 14 people found this instruction helpful

Parts Used

  • Speed Control Assembly

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerBernie from Lapeer MI

Erratic speed control

1. Removed the silver name band that encircles the mixer head by removing one philips screw at the rear of the head. 2. There are four philips head screws under the band. 3. Remove the four screws and lift the top half of the head from the machine. 4. Looking at the rear of the machine, the speed control is to the right (identify by the speed control knob. 5. Remove the two screws (philips) on each side of the speed control assembly. 6. Lift the speed control from the machine and let it hang by the connecting wires. 7. One at a time, remove the plugs that are connected to the speed control module and place then in the same location as the new part. 8. Set the old control aside. 9. Set the new controller in place and secure with the two philips screws removed during disassembly (note: do not over-tighten the screws as the tabs on the controller are plastic and can break if over-tightened). 10. Replace the cover and replace the four screws holding the cover in place and tighten securely. 11. Replace the beauty name place and tighten in place. This whole process took about 6 minutes from start to finish. The mixer now works like new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 5 people found this instruction helpful

Parts Used

  • Speed Control Assembly

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerKenneth from Clovs CA

The mixer only ran on high speed

I replaced the speed control board, however that did not correct the problem. I received the part very quickly and the install was easy but obviously it did not correct the problem so I will be returning the part. Hopefully that will go well also.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2