| |
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerStephen from Bethel ME
Latch broken
I did the job exactly as described in the video found at PartSelect's website. My applicance is hard wired which required tripping the circuit breaker that protects it. I found that my house circuit breaker panel was mismarked and the unit remained powered after I tripped the CB. ALWAYS test for power at any electrical connection with a test light or meter before touching an open wire or component.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerMark from San Francisco CA
Door latch plastic parts broke
I removed the screws holding the top control panel cover, removed the star screws holding the latch assembly on, tagged the 2 white wires and 2 black wires and unplugged all 4 wires. I installed and fastened the new latch assembly on, plugged the 4 wires in, and replaced the cover. Tested and it worked great.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customerpat from jacksonville AR
Broken latch
part wasent factory or not for that model,was able to use anyway was not able to put lower hook in slot so left out see what happens.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver
CustomerBrian from Rochester MN
Door latch broken
took old one off and was eaily replace . thanks alot, thanks for the very quick shipping, Brian
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
Customerraymond from pensacola FL
Dishwasher door latch broke, hard to open and close
I removed the knob, then the screws on top panel and removed the panel. I disconnected the wires , then I removed the two screws holding the lock assembly. Put in new lock assemly, connected the wires, put the scews in the lock and panel pushed the the nob on job done
NOTE: THE VERY FIRST THING I DID WAS DISCONNECT THE ELECTRICAL POWER GOING TO THE UNIT>
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerCindy from Decatur GA
Latch handle broke
followed suggestions from others who posted here. I am a first-timer - thanks so much! 1) cut power to dishwasher at breaker box. 2) removed upper front panel by unscrewing 6 phillips head screws holding it on. 3) removed broken latch assembly by unscrewing the two star-screws. 4) pulled off the 4 wires after noting how they were attached. 5) put wires onto new latch assembly. 6) installed the new assembly with the 2 star-screws. 7) put panel back on. 8) turned power back on. 9) checked function and everything works great. If only all household repairs were this easy. Thanks for the service and for the repair stories, they gave me the confidence to try it myself and it turned out GREAT!
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers, Wrench set
CustomerRobyn from Towson MD
Broken latch - could not open dishwasher
First I removed the front panel of the dishwasher by simply unscrewing about 10 screws. I then removed the control panel cover - super easy - a matter of unscrewing some screws. Disconnected 4 wires and removed the old, broken latch. The installation of the new latch was just as easy.
Simple and fast repair!
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsNutdriver, Screw drivers, Socket set
CustomerJason from St. Clair Shores MI
Latch handle broke off.
Well, once again my wife found another way to destroy a household appliance. I get a crossed and angry "the dishwasher broke!" Of course, it was my fault!
So, she wanted to get a brand new dishwasher because the handle broke. Instead, I went on Partselect.com, bought the part and it was shipped in a few days.
I took the facing off the dishwasher with a screw driver. Used a torque bit to take out the latch assembly, and replaced the latch. I kept the seal in because I dont see any leaking, but I stowed the new seal away as a "Just in case". About an hour later, works perfect without a problem.
So, instead of spending 300 on a new dishwasher, I spend 46 and have some extra money for the holidays!
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customertom from jamestown NY
Latch broke off
took the off , took off part and replaced
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers
CustomerMichael from Montclair VA
Door latch was broken
The part looked right, model numbers and location on the drawing matched up...but when it came it the electrical connections were not identical.
So I worked for 30-45 minutes to see if I could swap out the broken section on the old latch for the new part. Not a perfect fit...
So I cut the connections and rewired them...and nothing happened when I turned on the dishwasher.
After some trial and error I was able to get the dishwasher to run...but now it won't shut off when the door opens. Still trying to figure that out.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customerpatrick from Akron OH
Broken latch
removed six screws on door, inside found machine diagrams .ordered latch plugged new latch in put six screws back turned power back on test ran machine. and everything was good
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerRebecca from Siloam Springs AR
Dishwasher handle broke
I am totally ungifted mechanically but even I replaced the latch for the dishwasher in about five minutes. Piece of cake.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJason from Delaware OH
Handle broke
It was really easy,took about 15 minutes just like the other reviews say.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers, Screw drivers
CustomerMICHAEL from HESPERIA CA
Door latch fell off the dishwasher
Unpluged the unit,removed the screws from the interior panel, unpluged the wires, removed damaged part. Put back together in reverse order.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerBrigitte from Leander TX
Latch broke on a previously owned dishwasher
Took the old one off, put the new one on.
|