Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS971247
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
The Unstal kit had instructions to remove the ice maker....about six or seven steps that were easy to understand (for the most part)remove a couple of screws, unplug the wiring harness then install the ice cube tray holder into the same screw holes where the ice maker was previously installed. There was some confusion whether the holes where the wiring harness came out, should be covered with a plastic part, but the part did not fit easily and it didn't seem to be needed....I left it off.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Icemaker was held in place by 3 screws. Removed the screws and unclipped the wiring harness. The ice cube trays and shelf came with the uninstall kit, along with cap for wiring harness attached to refrigerator and a cover for the wiring harness hole at back of refrigerator.Snapped cap on wiring harness plug, then installed plastic cover over the wiring harness hole on the refrigerator with screw supplied with the kit. then used existing screws to attach the shelf.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.