960649-1-S-GE-WH12X10271        -Main Control Board
960649-1-S-GE-WH12X10271        -Main Control Board 960649-2-S-GE-WH12X10271        -Main Control Board 960649-3-S-GE-WH12X10271        -Main Control Board

Main Control Board

PartSelect Number PS960649

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Will Not Start.
  • Compare At

    $172.99
  • You Save

    $28.83
  • Your Price

    $144.16
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.5 / 5.0, 4 reviews What's this?
1-4 of 4
 

6 of 10 people found this instruction helpful

Parts Used

  • Main Control Board

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerAlex from Riverview FL

Washer cycles quit working. Control asm failed.

1. Unpluged power cord from power source.
2. Removed 4 knobs from front of control panel.
3. Removed 4 screws from top of control panel.
4. Laid control panel over on closed washer lid.
5. Removed wiring harness from control asm which is attached to back of control panel face plate.
6. Removed 5 screws that attaches control asy to back of control panel face plate.
7. Removed old control asm and replaced with new.
8. Reverse removal procedure and plug to power source and run washer through a few cycles.
9. This self repair took about 15 to 30 minutes and saved me about $150.00 on a service call.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 5 people found this instruction helpful

Parts Used

  • Main Control Board

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerRalph from Taft CA

The water would not drain on certin cycles

First, Unpluged the washer so there was no power to the unit. Removed 4 screws from the control panel. Disconnected the wiring from the control panel. Removed the mounting screws and removed the panel. Installed the new panel and screws. Connected the wiring and installed the panel back on the washer. pluged the unit back in and turned it on. Very easy fix, No problems with the washer now.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 4 people found this instruction helpful

Parts Used

  • Main Control Board

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

Customerjoseph from Winter Springs FL

Clothes washer was shutting in mid cycle

removed top cover,removed and replaced main control board. Very simple and low cost repair

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 4 people found this instruction helpful

Parts Used

  • Main Control Board

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

Customerkeith from crescent FL

Would not spin out the wash

the repair whent very easy like you said thankyou

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4