Quick Question!

Have you ever purchased from PartSelect.com before?

959485-1-S-GE-WD30X10020        -Cage Roller Bearing Assembly
959485-1-S-GE-WD30X10020        -Cage Roller Bearing Assembly 959485-2-S-GE-WD30X10020        -Cage Roller Bearing Assembly http://www.partselect.com/Schematics/GE/00125020i03.gif

Cage Roller Bearing Assembly

PartSelect Number PS959485

Aides with movement or sliding of the dishrack.

This part works with the following brands: GE, Hotpoint & Kenmore.

Compare At

$10.27

You Save

$1.71

Your Price

$8.56
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 5.0 / 5.0, 3 reviews What's this?
1-3 of 3
 

15 of 21 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools:
Customer: steve from ramsey, MN

Broken drawer slides

The repair was very easy, I just had to replace some bad bearing slides in the drawer pull. Remove the end cap, remove the top drawer, remove the old bearing slide from the drawer slide and snap the new one in. finally replacing the end caps.
Ordering the parts was easy and delivery was fast.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

4 of 10 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools:
Customer: George from Cincinnati, OH

Ball bearings falling out of the upper dish rack

pulled the end caps, pulled the upper dish rack out. Installed the rear end cap on the right hand side of the inside slider for the rack. installed the bearing and slider in position. Put the upper rack back in and installed the front end caps.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

4 of 17 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Pliers
Customer: Karl from Ke West, FL

Top rack was getting stuck when sliding out.

Pulled out the rack installed new slides, rollers and endcaps,It was a snap !

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-3 of 3