Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS958986
This end cap is sold individually. It is the same end cap used on the right and left side, for both front and back. It attaches to the end of the upper rack slide rail, and prevents the rack from falling when being pulled out too far.
This part works with the following brands: GE, Hotpoint & Kenmore.
The repair was very easy, I just had to replace some bad bearing slides in the drawer pull. Remove the end cap, remove the top drawer, remove the old bearing slide from the drawer slide and snap the new one in. finally replacing the end caps. Ordering the parts was easy and delivery was fast.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed racks and replaced snap in rollers in bottom shelf and installed new stops in top rack.No tools needed
pulled the end caps, pulled the upper dish rack out. Installed the rear end cap on the right hand side of the inside slider for the rack. installed the bearing and slider in position. Put the upper rack back in and installed the front end caps.
Ordering was a breeze, the diagrams made it simple! Parts were ordered, parts were shipped, received and installed. Wonderfully easy.
Pulled out the rack installed new slides, rollers and endcaps,It was a snap !
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.