958986-1-S-GE-WD12X10184        -Upper Rack End Cap
958986-1-S-GE-WD12X10184        -Upper Rack End Cap 958986-2-S-GE-WD12X10184        -Upper Rack End Cap 958986-3-S-GE-WD12X10184        -Upper Rack End Cap

Upper Rack End Cap

PartSelect Number PS958986

This end cap is sold individually. It is the same end cap used on the right and left side, for both front and back. It attaches to the end of the upper rack slide rail, and prevents the rack from falling when being pulled out too far.

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $3.60
  • You Save

    $.60
  • Your Price

    $3.00
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 5.0 / 5.0, 5 reviews What's this?
1-5 of 5
 

11 of 15 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

Customersteve from ramsey MN

Broken drawer slides

The repair was very easy, I just had to replace some bad bearing slides in the drawer pull. Remove the end cap, remove the top drawer, remove the old bearing slide from the drawer slide and snap the new one in. finally replacing the end caps.
Ordering the parts was easy and delivery was fast.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 3 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerJay from Lynnwood WA

Top tray would pull out due to stops being worn and missing. Also bottom rack had missing rollers

Removed racks and replaced snap in rollers in bottom shelf and installed new stops in top rack.

No tools needed

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 8 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerGeorge from Cincinnati OH

Ball bearings falling out of the upper dish rack

pulled the end caps, pulled the upper dish rack out. Installed the rear end cap on the right hand side of the inside slider for the rack. installed the bearing and slider in position. Put the upper rack back in and installed the front end caps.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 2 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

Customercaroline from Flagstaff AZ

Dishwasher was missing a few elements . . .

Ordering was a breeze, the diagrams made it simple! Parts were ordered, parts were shipped, received and installed. Wonderfully easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 10 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers

CustomerKarl from Ke West FL

Top rack was getting stuck when sliding out.

Pulled out the rack installed new slides, rollers and endcaps,It was a snap !

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-5 of 5